Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Attention! With respect to protection from el. shock
and preservation of the class of protection, all mainte-
nance and service operations requesting jig saw case
removal must be performed by the authorized service centre
only!
The current list of authorized service centres can be found at our
website www.narex.cz, section "Service Centres".
Storage
Packed appliance may be stored in dry, unheated storage place
with
temperature not lower than -5 °C.
Unpacked appliance should be stored only in dry storage place with
temperature not lower than +5 °C with exclusion of all sudden
temperature changes.
Environmental protection
Power tools, accessories and packaging should be sorted for
environmental-friendly recycling.
Only for EU countries:
Do not dispose of power tools into household waste!
According to the European Directive 2002/96/EC on waste elect-
rical and electronic equipment and its incorporation into national
law, power tools that are no longer suitable for must be separa-
tely collected and sent for recovery in an environmental-friendly
manner.
Warranty
Our equipment is under warranty for at least 12 months with regard to
material or production faults in accordance with national legislati-
on. In the EU countries, the warranty period for exclusively private
use is 24 months (an invoice or delivery note is required as proof
of purchase).
Damage resulting from, in particular, normal wear and tear, over-
loading, improper handling, or caused by the user or other da-
mage caused by not following the operating instructions, or any
fault acknowledged at the time of purchase, is not covered by the
warranty.
Complaints will only be acknowledged if the equipment has not been
dismantled before being sent back to the suppliers or to an autho-
rised NAREX customer support workshop. Store the operating
instructions, safety notes, spare parts list and proof of purchase
in a safe place. In addition, the manufacturer's current warranty
conditions apply.
Information about noise level and
vibrations
The values have been measured in conformity with EN 60745.
Acoustic pressure level L
= 91 dB (A)
pA
Acoustic power level L
= 102 dB (A)
wA
In accuracy of measurements K = 3 dB (A)
ATTENTION! Noise is generated during work!
Use ear protection!
The weighted value of vibrations affecting hands and arms:
Chiselling:
a
= 18.6 m.s
hHD
Chiselling:
a
= 24.2 m.s
hHD
In accuracy of measurements K = 1.5 m.s
The emission values specified (vibration, noise) were measured in
accordance with the test conditions stipulated in EN 60745 and are
intended for machine comparisons. They are also used for making
preliminary estimates regarding vibration and noise loads during
operation.
The emission values specified refer to the main applications for
which the power tool is used. If the electric power tool is used for
other applications, with other tools or is not maintained sufficient-
ly prior to operation, however, the vibration and noise load may be
higher when the tool is used.
Take into account any machine idling times and downtimes to esti-
mate these values more accurately for a specified time period. This
may significantly reduce the load during the machine operating
period.
Certificate of Conformity
We declare that the device meets requirements of the following
standards and directives.
Safety:
EN 60745-1; EN 60745-2-6
Directive 2006/42/EC
Electromagnetic compatibility:
EN 55014-1; EN 55014-2; EN 61000-3-2;EN 61000-3-3
Directive 2004/108/EC
2009
Narex s.r.o.
Chelčického 1932
470 01 Česká Lípa
Changes are reserved
English
-2
-2
-2
Antonín Pomeisl
CEO of the company
December 29, 2009
15
Publicidad
Tabla de contenido
