Kinderkraft Vado Manual De Uso página 35

reaches the weight of 13 kg. We recommend using additional internal foam filling until the
child reaches the weight of 5.5 kg. The foam filling can be removed using the removable
pocket at the back of the newborn cushion.
4.2 Headrest height
Pull the headrest adjustment button, lift or push-in the headrest to adjust its height (Fig.
4.2a). The headrest may be adjusted in 10 different heights.
• In the case of weight group 0+ and 1, the headrest can be adjusted at 8 different heights
without removing the shoulder strap pads. The proper shoulder strap height should be set
to make the strap entering the car seat backrest just above the child's shoulders or equally
with their height. Ensure that the shoulder straps fit well to the child's shoulders.
• The remaining 3 positions for weight group 2 can be adjusted by removing the shoulder
strap pads and hiding the harness (see Section 6.1). The shoulder belt should be positioned
between the shoulder and the neck of the child. The headrest should fit well to the child's
head.
4.3 Backrest tilt adjustment mechanism (Fig. 4.3).
The tilt of the safety seat can be adjusted in 4 positions using the lever (H). Pull the lever, and
then slide the seat. Release the lever in the desired position. Move the seat slightly until you
hear a clearly audible "click" − the seat is secured in position.
In groups 0+ and 1 (up to 18kg) with the rear-facing seat, use maximum tilt position.
In group 1 (9kg-18kg) with the front-facing seat, all positions may be used.
In group 2 (15kg -25kg) with the front-facing seat, use the most vertical (straight) position.
4.4 Securing your child with the harness
• Loosen the harness straps by pressing the button at the adjustment strap (D) and pulling
the harness. Remember! Do not pull the shoulder pads (Fig. 4.4a). Unlock the buckle (Fig.
4.4b).
• Place harness straps on the sides of the seat (Fig. 4.4c). Place your child in the seat.
• Adjust the headrest to the child's height Fig. 4.4d) (see also Section 4.2).
• Join two buckle latches to engage them and insert them into the buckle (G) until you hear
a "click" (Fig. 4.4e).
4.5 Tightening the harness (Fig. 4.5)
• Pull the shoulder straps to eliminate play in the hip strap so that the harness lies flat.
• Pull the harness with the harness adjustment strap (D), until the harness lies flat and close
to the child's body. Ensure that the shoulder straps fit well to the child's shoulders. Proper
tension is ensured, if you can insert one finger (approx. 1 cm) between the shoulder strap
and the chest of the child.
NOTE The harnesses lap straps must be placed as low as possible on the child's hips. Make
sure that the harness straps are not twisted.
35