Kinderkraft Vado Manual De Uso página 40

• Put together the shoulder straps and the harness adjusting strap using the metal connector
(Fig. 6.1f). Make sure that the harness straps are not twisted.
• Slide the cover on the seat, fasten the latches inside the seat (in the seat corners).
• Adjust the fabric to the gaps around the guide (I), and insert the fabric into the gaps around
the seat (Fig. 6.3g).
• Check that the harness straps are not twisted.
6.4 Cleaning
Use the original cover only, since it is essential for the safety of the seat.
NOTE Do not use the seat without the cover.
• The cover can be removed and washed in mild detergent using delicate washing program
(30°C). Observe the washing instructions on the label placed on the cover. The cover may
not be spun or tumble dried (as it may result in separation of the material layers).
• Plastic parts can be cleaned with water and soap. Do not use aggressive cleaning agents
(such as solvents).
• The harness may be cleaned using warm water and soap.
7. Warranty
1. All Kinderkraft products are covered by a 24-month warranty. The warranty period
begins on the date of releasing the product to the Buyer.
2. The warranty is valid for products sold in the following countries: France, Spain,
Germany, Poland, United Kingdom, Italy.
3. In countries not listed above warranty terms and conditions are determined by the
Seller.
4. It is possible to extend the warranty period to 120 months (10 years). Full text of the
terms and conditions and warranty extension registration form are available at
WWW.KINDERKRAFT.COM
5. The warranty is valid only in the country where the purchase was made.
6. Complaints should be
WWW.RMA.KINDERKRAFT.COM
7. The warranty shall not cover:
a. claims arising from product specifications, as long as they comply with those specified
by the manufacturer in the instruction manual or other documents of a legislative
nature;
b. product damage caused by improper maintenance or use of inadequate chemicals;
c. colour change (discolouration) when the product has been exposed to direct sunlight
against the instructions provided in the instruction manual;
d. tear, wear, crack of fabric/plastic that is the fault of the Customer;
e. reduction in the quality of the product and consumables due to normal wear and tear;
f. products which have not been used according to specifications;
submitted by completing the form available
40
at