Replacing The Tires; Removing The Old Tires; Assembling The New Tires; Troubleshooting - Zodiac VORTEX 3 Instrucciones De Montaje Y De Uso

2-Notice CO ANG.qxd 13/09/10

6.1. REMOVING THE OLD TIRES

Pull on the rear side of the old tire
(Diagram
lip from the wheel.
Remove the old tire (15-2).

6.2. ASSEMBLING THE NEW TIRES

Present the tires on the wheel
sure that the "inside" mark on the walls is on the inside part of the wheel.
Push one portion of the tire around the wheel and fit the rib of the tire in the groove of the
wheel (16-2).
Install the rest of the tire on the wheel and verify the rib of the tire fit well with the groove of
the wheel (16-3).
Adjust the rib of the inner side of the tire in the groove of the wheel (16-4). You may turn the wheel
gently if needed.
Diagram 16
The cleaner does not stay firmly on the pool bottom:
There is air in the appliance casing. Repeat the immersion operations strictly complying with the
instructions in the "Cleaner immersion" paragraph.
The cleaner does not or no longer climbs the pool sides:
This may have two causes:
•
the filter is full or dirty: all you need to do is clean it;
•
although the water seems clear, microscopic algae, invisible to the human eye, are present in
the pool. As a result the pool sides become slippery and prevent the cleaner from climbing.
Carry out a shock chlorination treatment and slightly reduce the pH. Do not leave the cleaner
in the pool during this treatment.
On start-up the cleaner does not move:
•
Check that the outlet to which the control box is connected is receiving a power supply.
•
Check that you have started one of the two programmes, check that the indicator for the
selected programme is lit.
If the problem persists contact your retailer.
9:12 Page 22

6 / REPLACING THE TIRES

15-1) to remove the tire
(Diagram 16-1). Pay attention to the orientation of the tyre: make

7 / TROUBLESHOOTING...

22
Diagram 15