AERMEC WRC1 Manual De Usario página 68

EN
This parameter is used to scroll all project numbers (and consequently all the
units in the system) associated with the unit number (in relation to the total num-
ber of internal units in the system); to scroll the list of units, perform the following
operations:
(1) Select the operating parameter "C18";
(2) Press the "MODE" button to enter the list of indoor units (after entering this list,
the set-point area will display the number of the unit while the timer zone will dis-
play the project number for the indoor unit in question); if the Indoor unit current-
ly displayed is the system master, the "MASTER" icon will be displayed);
(3) Press the arrow buttons to scroll the indoor units;
(4) Press the "SWING/ENTER" button to return to the list of operating parameters
Display all project num-
bers at the same time
WARNING:
• after displaying parameter C18, all indoor unit wired panels will display (in the
timer zone) their specific project numbers, which will remain displayed until this
function is closed;
• reminder: it will not be possible to enter this parameter if access is attempted
from a slave wired panel (installation with two wired panels connected to the
same indoor unit);
• reminder: pressing the "ON/OFF" button on any wired panel during this func-
tion will immediately finish it;
• if, when displaying parameter C18, no operation is performed for more than 20
seconds, the function is automatically exited
Reserved parameter
SETPOINT zone
TIMER zone
68