Promax TV EXPLORER II Manual De Instrucciones página 113

USER'S MANUAL. TV EXPLORER II/II+
The TV EXPLORER II / II+ is designed to integrate measurements that require
different operating configurations. In this way it incorporates a specific function to
facilitate the alignment of antennas. When activating the alignment function the
instrument is set automatically to offer a fast spectrum sweep and a high sensitivity
graphical bar that allows fine adjust for the maximum signal. In addition it includes a
module for the powering of LNBs and DVB-T antennas to 5V, and the commands for
the programming of DiSEqC 1.2 and SatCR devices.
The can be updated to new software versions that extend the available
EXPLORER
functions in the future. That means it can incorporate new benefits without additional
cost. For example, in the test of satellite signals distribution networks, using
combined with an IF generator permits to carry out an easy verification of the
installations before commissionning.
The spectrum analyser features with high accuracy, resolution, sensitivity and
sweep speed allows the instrument to be very useful for applications as the installation
of antennas or the detection of complex impulsional noise events. It presents an
innovative control system based on four arrows, that makes the use of the spectrum
analyser very intuitive. The arrows allow adjusting the reference level by steps of 10 or
5 dB and the frequency margin span on screen.
To enhance its convenience of use, it includes memories to store automatically
the different data acquisitions, i.e.: acquisition name, test points, frequency, channel
plan, etc.,. Moreover, the DATALOGGER function makes it much easier to test systems
in which a large number of measurements have to be made, and enables further
processing of all the information acquired using a computer system. The equipment is
able to generate automatic measurement reports and to update itself through Internet by
means of PkTools provided software.
The TV EXPLORER II+ in addition, allows to record and to play a TS
corresponding to services from a digital channel. For it, the equipment uses an internal
memory of up to 1 GB.
Also, this meter incorporates a DiSEqC
supply different voltages to the external unit (5 V / 13 V / 15 V / 18 V / 24 V) and includes
an EUROCONNECTOR, or Scart connector, for audio/video input/output.
The TV EXPLORER II / II+ is powered by rechargeable battery or connected to
the mains through the supplied external DC power charger.
It incorporates a USB port, which enables the communication with a PC and to
download dataloggers and channel plans.
2 TM
DiSEqC
is a trademark of EUTELSAT.
12/2013
2
command generator and permits to
Page 3