Promax TV EXPLORER II Manual De Instrucciones página 186

The steps to go through to set up the digital terrestrial reception are the next:
1. Press the key
terrestrial frequency band.
2. Press the key
measurement mode for Digital TV.
3. Check the led indicator "D" and the led indicator "T" are lighted.
4. Enter parameters manually to lock signal or press
Identification) for an automatic identification of the signal (Figure 53.-).
FREQ:
CHANNEL:
TESTING FOR ANALOG
NOT ENOUGH LEVEL 46.2 < 50.0 dBµV
TESTING DVB-T/H
POWER OK 51.6 >= 32.0 dBµV
TRYING CURRENT DVB-T/H CONFIG.
DIGITAL: DVB-T/H
SEARCHING NETWORK NAME
CANCEL
Figura 53.- Automatic identification of the signal.
Now, the ECHOES function is available. The steps to go through in order to select
the ECHOES function are the next:
1. Press (short pulsation) the key
Utilities.
2. Select the option COFDM ECHOES (Figure 54.-).
-7 -6
FREQ:
CH:
MPEG-2 TS DVB-T
Page 76
USER'S MANUAL. TV EXPLORER II/II+
[14] (Satellite / Terrestrial Band) to select the TV
[17] (Measurement Configuration) to select the
482.00 MHz DL:
22
[22] (Utilities) to access the menu
UTILITIES
EQUIPMENT INFO.
>>SAVE AS: SPECTRUM
CONSTELLATION
-5 QEF -3
SPECTROGRAM
650.00 MHz C/N:
MER BY CARRIER
-3 kHz POWER:
COFDM ECHOES
43 MER:
MEROGRAM
CBER:
ATENUATION TEST
» VBER:
RUN DATALOGGER
Figure 54.-. UTILITIES Menu.
[25] (Automatic
482.0 MHz
-2 -1
>21.3 dB
55.8 dBµV
19.5 dB
5.0E-2
5.3E-4
12/2013