Emission Levels; Compressed-Air Supply And Com- Missioning; Ias 3 Hose Connector; Switch On/Off - Festool LRS 400 Manual De Instrucciones

4.3

Emission levels

Levels determined in accordance with EN ISO
15744/ISO 28927 are typically:
Sound pressure level
Sound power level
Uncertainty
Wear ear protection.
Vibration emission
level
3 directions
Handle
Auxiliary handle
1 direction (According to the old EN ISO 8662)
Handle
Auxiliary handle
The specified emission values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary esti-
mates regarding vibration and noise loads during
operation.
– They represent the primary applications of the
power tool.
Increase possible for other applications, with other
insertion tools or if not maintained adequately. Take
note of idling and downtimes of machine!
5 Compressed-air supply and com-
missioning
CAUTION
Risk of injury
Make sure that the pneumatic tool is switched

off when you connect the compressed-air sup-
ply.
5.1

Compressed-air processing

The Festool service unit should always be used to
ensure that Festool pneumatic tools function cor-
rectly. Consisting of a filter, control unit, condensa-
tion drain and lubricator, the service unit cleans and
lubricates the compressed air and keeps it free of
condensation. Here, the lubricator should be set so
that a drop is applied to the compressed air approx.
every 7-10 minutes.
Damage that occurs as a result of incorrect com-
pressed-air processing is excluded from warranty
claims.
L = 80 dB(A)
PFA
L = 91 dB(A)
WA
K = 3 dB
a Uncer-
h
tainty K
2 2
5.8 m/s 3.0 m/s
2 2
5.7 m/s 3.0 m/s
2 2
4.5 m/s 2.0 m/s
2 2
4.0 m/s 1.0 m/s
 We recommend a service unit with a 3/8" con-
nector, when up to two Festool pneumatic tools
are used.
A compressor that supplies at 500 l/min and at an
operating pressure of 6 bar should be used to sup-
ply compressed-air.
The diameter of the piping system must be suffi-
ciently large (at least 9 mm).
5.2

IAS 3 hose connector

The sander is a pneumatic tool for connection to the
Festool IAS 3 system. This hose system combines
three functions in one hose:
• Compressed-air supply [3-1]
• Exhaust air extraction [3-2]

• Dust extraction [3-3]

Connection and disconnection - see Fig. [2].
5.3

Switch on/off

Pressing the lever [1-1] switches on the com-
pressed-air tool. Releasing the lever switches the
machine off again.
6 Settings
CAUTION
Risk of injury
The machine should always be disconnected

from the compressed air supply before any work
is carried out on the machine.
6.1 Electronics
Speed adjustment
You can regulate the rotational speed steplessly be-
tween 5500 - 8000 rpm using the adjusting wheel
[1-2].
This enables you to optimise the cutting speed to
suit the material.
6.2 Dust extraction
WARNING
Dust hazard
Dust can be hazardous to health. Always work

with a dust extractor.
Always read applicable national regulations be-

fore extracting hazardous dust.
To guarantee optimal dust extraction, we recom-
mend using Festool extractors with automatic
switch-on/switch-off device for compressed air
machines.
LRS 400
GB
15