Emission Levels; Commissioning - Festool PLANEX LHS 225 EQ Manual De Instrucciones Original/Lista De Piezas De Repuesto

ence can dig into the workpiece surface at
the jamming point, causing the disc to be
expelled. The disc can either fl y towards or
away from the user, depending on the direc-
tion of rotation of the disc at the jamming
point. This can also cause sanding discs to
break.
A kickback is the result of misuse of the ma-
chine and/or incorrect method of work or oper-
ation and can be avoided by closely observing
the following precautionary measures.
- Always hold the machine fi rmly and
position your body and arms such that
you can control any kickback force.
Always use the auxiliary handle, if included
in the delivery, to ensure optimum control
over kickbacks or reaction torques during
start-up. The user can control reaction tor-
ques or kickbacks if suitable precautionary
measures are taken.
- Never place your hands near rotating
tools. Tools can kick back over your hand.
- Never position your body in the area in
which the machine moves in the event
of a kickback. A kickback accelerates the
machine in the direction of rotation op-
posed to the disc at the jamming point.
- Take extra care when working in cor-
ners, on sharp edges, etc. Avoid kick-
backs and prevent the tool from seizing.
Corners, sharp edges or a jump back tend
to cause the rotating tool to catch, thus
leading to a loss of control or a kickback.
Special safety instructions for fi ne sanding
- Do not use excessively large sanding
discs when fi ne sanding. Observe the
specifications of the manufacturer
when selecting abrasive discs. A sand-
ing disc that is too large and protrudes over
the sanding pad represents a cutting injury
hazard and can cause catching, disc tears
or kickbacks.
Additional warning notes
- Hold the machine firmly with both
hands and assume a stable stance
when performing work. Hold the ma-
chine with both hands to guide more se-
curely.
- If potentially explosive or self-igniting
dust is produced during sanding, the
processing instructions of the material
manufacturer must be observed under
all circumstances.
All manuals and user guides at all-guides.com
17
- Harmful/toxic dusts can be produced
during your work (e.g. lead-containing
paint, some types of wood and metal).
Contact with these dusts, especially inhaling
them, can represent a hazard for operating
personnel or persons in the vicinity. Comply
with the safety regulations that apply in your
country. Connect the electric power tool to a
suitable extraction system. To protect your
health, wear a P2 protective mask.
- Never use machines with a damaged
cable. Do not touch damaged cables
and pull the plug from the mains
power supply if the cable becomes
damaged during work. Damaged cables
increase the risk of electric shock.
- Use a maximum of two extension pipes
on the machine.

5.3 Emission levels

Levels determined in accordance with EN
60745 are typically:
Sound pressure level
Noise level
Measuring uncertainty allowance K = 3 dB
CAUTION
The noise produced during work may
damage your hearing.
Wear ear protection!
•
Overall vibration levels (vector sum for three
directions) measured in accordance with EN
60745:
Vibration emission level
(3-axis)
Uncertainty
6

Commissioning

WARNING
Risk of accident if the machine is ope-
rated using unauthorised voltages or
frequencies.
- The mains voltage and the frequency of
the power source must correspond with
the specifi cations on the machine's name
plate.
- In North America, only Festool machines
with voltage specifi cations of 120 V may
be used.
82 dB(A)
93 dB(A)
a < 2.5 m/s
2
h
K = 3 m/s²