Descargar Imprimir esta página

Fein Turbo I Instrucciones De Uso página 7

Ocultar thumbs Ver también para Turbo I:

Publicidad

Idiomas disponibles

Idiomas disponibles

OBJ_BUCH-0000000150-004.book Page 7 Tuesday, May 5, 2015 10:33 AM
Do not misuse the power supply cord to pull
the vacuum cleaner around or pull the mains
plug from the socket outlet. Keep the power
supply cord away from heat, oil, sharp edges,
or rotating parts. Do not drive over or pinch
the power supply cord. Damaged or entangled
power supply cords increase the risk of an
electric shock.
Before replacing accessories, pull the mains
plug from the socket outlet. This safety mea-
sure reduces the risk of electric shock.
Do not vacuum materials that are hazardous
to one's health, e. g., dust from beech or oak
wood, masonry dust, asbestos. These materi-
als are considered carcinogenic.
Provide for good ventilation of the workplace.
Do not vacuum inflammable or explosive liq-
uids; for example, gasoline, oil, alcohol, sol-
vents. Do not vacuum hot or inflammable
dusts. Do not operate the machine in rooms
where the danger of an explosion exists. The
dusts, vapors or liquids can ignite or explode.
Do not rivet or screw any name-plates or
signs to the vacuum cleaner. If the insulation
Emission values for sound and vibration
(Two-figure – specifications as per IEC 60335-2-69)
Sound emission
A-weighted emission pressure power level measured at
L
the workplace
(re 20 μPa), in decibels
pA
K
Measuring uncertainty
REMARK: The sum of the measured emission value and respective measuring inaccuracy
represents the upper limit of the values that can occur during measuring.
Wear hearing protection!
Measured values determined in accordance with the corresponding product standard.
is damaged, protection against an electric
shock will be ineffective. Adhesive labels are
recommended.
Do not use accessories not specifically
intended or recommended for this vacuum
cleaner by FEIN. Just because the accessory
can be attached to your vacuum cleaner, it
does not assure safe operation.
Before putting into operation, check the
power connection and the power plug for
damage.
poses specified in of the operating instructions.
Please also observe the operating instruc-
tions and safety warnings of the power tool
being connected to the socket outlet of the
vacuum cleaner.
Recommendation: Always operate the power
tool via a ground-fault circuit interrupter with
a rated residual current of 30 mA or less.
The vacuum cleaner may only be stored
indoors.
, in decibels
pA
Use the vacuum cleaner's
WARNING
socket outlet only for the pur-
Turbo I
67
2
en
7
Turbo II/
Turbo II S2106
67
2

Publicidad

loading

Este manual también es adecuado para:

Turbo iiTurbo ii s21069 20 279 20 28