Maintenance And Service; Maintenance And Cleaning - Bosch DLE 50 Professional Instrucciones De Servicio

OBJ_BUCH-135-003.book Page 19 Monday, November 26, 2007 2:42 PM
Troubleshooting – Causes and
Corrective Measures
Cause
Temperature indicator b flashes;
measurement not possible
The measuring tool is out-
side the operating tempera-
ture range from – 10 °C to
+ 50 °C (in the function
continuous measurement
up to +40 °C).
Battery indication a is indicated
Battery voltage decreasing
(measurement still possible)
Battery indication a flashes, measurement not
possible
Battery voltage too low
The indications "ERROR" and "–––––" are
indicated in the display
The angle between the
laser beam and the target is
too acute.
The target surface reflects
too intensely (e.g. a mirror)
or insufficiently (e.g. black
fabric), or the ambient light
is too bright.
The laser beam outlet 19 or
the reception lens 20 are
misted up (e.g. due to a
rapid temperature change).
The indication "ERROR" flashes at the top in
the display
Addition/Subtraction of
measured values with differ-
ent units of measure
Unreliable measuring result
The target surface does not
reflect correctly (e.g. water,
glass).
The laser beam outlet 19 or
the reception lens 20 are
covered.
1 609 929 P14 • 26.11.07
Corrective Measure
not correct an error, have the measuring tool checked
by an after-sales service agent for Bosch power tools.
Wait until the measur-
Accuracy Check of the Measuring Tool
ing tool has reached
the operating tempera-
The accuracy of the measuring tool can be checked
ture
as follows:
•
Replace batteries
•
The measuring error must not amount to more than a
maximum of ±3 mm. Keep a record of the measure-
ments in order to compare the accuracy at a later time.
Replace batteries

Maintenance and Service

Enlargen the angle
between the laser
beam and the target

Maintenance and Cleaning

Work with the laser
target plate 23
Store and transport the measuring tool only in the sup-
(accessory)
plied protective case.
Keep the measuring tool clean at all times.
Do not immerse the measuring tool into water or other
Wipe the laser beam
fluids.
outlet 19 and/or the
Wipe off debris using a moist and soft cloth. Do not
reception lens 20 dry
use any cleaning agents or solvents.
using a soft cloth
Maintain the reception lens 20 in particular, with the
same care as required for eye glasses or the lens of a
camera.
Only add/subtract
If the measuring tool should fail despite the care taken
measured values with
in manufacturing and testing procedures, repair
the same units of
should be carried out by an authorized after-sales
measure
service centre for Bosch power tools.
In all correspondence and spare parts orders, please
Cover off the target
always include the 10-digit article number given on
surface
the type plate of the measuring tool.
In case of repairs, send in the measuring tool packed
Make sure that the in its protective case 24.
laser beam outlet 19 or
the reception lens 20
are unobstructed
The measuring tool monitors the cor-
rect function for each measurement.
When a defect is determined, only the
symbol shown aside flashes in the dis-
play. In this case, or when the above
mentioned corrective measures can-
Select a permanently unchangeable measuring
section with a length of approx. 1 to 10 metres; its
length must be precisely known (e.g. the width of
a room or a door opening).
Measure the distance 10 times after another.
English | 19