Dolmar AT-1831 C Manual De Instrucciones página 8

ENGLISH (Original instructions)
1. Battery cartridge
2. Speed adjusting dial
3. Indication lamp
4. Power button
5. Lock-off lever
6. Hanger (suspension point)
7. Grip
8. Switch trigger
9. Guard
10. Wire guard
11. Cutting tool
12. Shoulder harness
13. Cap
14. Red indicator
15. Button
16. Power indicator
17. Reversing switch
SPECIFICATIONS
Model
Type of pipe
No load speed
Overall length with nylon cutting head
Split length
Cutting diameter with nylon cutting head
Net weight
Rated voltage
Standard battery cartridge and charger
Always keep the combinations of
battery/charger on the right columns.
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Noise
Model
AT-1831 C/AT-1831 CD
• Even if the sound pressure level listed above is 80 dB (A) or less, the level under working may exceed 80 dB (A). Wear
ear protection.
Vibration
Model
AT-1831 C/AT-1831 CD
• The declared vibration emission value has been
measured in accordance with the standard test method
and may be used for comparing one tool with another.
• The declared vibration emission value may also be
used in a preliminary assessment of exposure.
8
Explanation of general view
18. A position depressed for normal
operation
19. B position depressed for weed
and debris removal
20. Star marking
21. Battery indicator
22. Most effective cutting area
23. Joint
24. Lock lever
25. Joint cover
26. Lever
27. Pipe (Cutting tool side)
28. Concave portion
29. Protrusion
30. Hex bolts
31. Cover
32. Clamps
Integrated pipe
Sound pressure level
L (dB (A))
PA
79
Front grip
Uncertainty K
2
a (m/s )
h
(m/s
2.5 1.5
ENG901-1
AT-1831 C
3,500 - 6,000 min
1,843 mm
—
300 mm
3.9 kg
D.C. 18 V
AP-183/LG-184
Uncertainty K (dB (A))
0.7
Rear grip
2
a (m/s )
2 h
)
2.5
WARNING:
• The vibration emission during actual use of the power
tool can differ from the declared emission value
depending on the ways in which the tool is used.
• Be sure to identify safety measures to protect the
operator that are based on an estimation of exposure in
the actual conditions of use (taking account of all parts
of the operating cycle such as the times when the tool
is switched off and when it is running idle in addition to
the trigger time).
33. Cutting tool side
34. Spacer
35. Grooves
36. Protector
37. Concave portions
38. Protector holder
39. Protrusions
40. Holes
41. Nylon cutting head
42. Metal guard
43. Receive washer
44. Hex wrench
45. Buckle
46. Hook
47. Hex bolt
48. 80-100 mm
AT-1831 CD
Splittable pipe
-1
982 mm
4.1 kg
Applicable standard or
directive
2000/14/EC
Uncertainty K
2
(m/s )
1.5
Applicable
standard or
directive
EN786