Free Saw Guidance Along A Scribe Mark; Service And Maintenance; Cleaning The Chip Ejection Opening; Accessories - Festool CARVEX PS 420 EBQ Manual De Instrucciones

English
When working, hold the electric power tool by
the handle and guide it along the desired cut­
ting line. For precise cuts and smooth running,
use two hands to guide the electric power tool.
8.1

Free saw guidance along a scribe mark

The triangular pointer on the splinterguard
[4-1] indicates the cutting line of the saw blade.
This facilitates sawing along a scribe mark.
8.2 Lighting
WARNING
Stroboscopic light could lead to misjudge­
ment of the saw blade position
Risk of injury
► Ensure the work area is well illuminated.
A steady light or stroboscopic light is installed
to illuminate the cutting line:
Up to approx. 2100 rpm: Steady light
From approx. 2100 rpm upwards: Stroboscopic
light
In the overhead position (+/- 45°), the
lighting is switched off completely.
If required, you can adjust the lighting:
► Plug in the electric power tool.
► Press both buttons [1-2] simultaneously
and hold for approx. 10 s until a beep
sounds.
► Release both buttons [1-2].
► Press the left button (on the pendulum
stroke side) the specified number of times
to set the desired mode:
Mode Indication dur­
ing configura­
tion
1 Light flashes
2 Light on
3 Light off
► Press the right button to save the setting.
20
Behaviour during op­
eration
With stroboscope
(standard)
Steady light without
stroboscope
Light switched off
9

Service and maintenance

WARNING
Risk of injury, electric shock
► Always pull the mains plug from the socket
before performing any servicing and main­
tenance work.
► All maintenance and repair work which re­
quires the motor housing to be opened
should always be carried out by an author­
ised service workshop.
Customer service and repairs must
only be carried out by the manufac­
turer or service workshops. Find the
nearest address at:
www.festool.co.uk/service
Always use original Festool spare
EKAT
4
parts. Order no. at:
www.festool.co.uk/service
5
3
2
1
9.1 Observe the following information
► Check the guidance roller regularly for
wear.
► Regularly remove dust deposits from the
chip guard.
► Regularly clean the base runner to prevent
scratches and cores on the surface.
► Damaged safety devices and components
must be repaired or replaced in a recog­
nised specialist workshop, unless otherwise
indicated in the operating manual.
► To ensure constant air circulation, always
keep the cooling air openings in the motor
housing clean and free of blockages.
► Keep the contacts on the power tool, charg­
er and battery pack clean.
9.2

Cleaning the chip ejection opening

Clean the chip ejection opening [1-15] regularly
to prevent blockages:
► Remove the chip guard.
► Use a brush or vacuum cleaner to clean the
chip ejection opening.
► Reinsert the chip guard.

10 Accessories

The order numbers of the accessories and tools
can be found in the Festool catalogue or on the
Internet at "www.festool.com".
10.1 Saw blades, other accessories
In order to saw different materials quickly and
cleanly, Festool offers saw blades for all appli­