Sawing Along The Scribe Mark; Gypsum And Cement-Bound Fibreboards; Service And Maintenance - Festool TSC 55 KEB Manual De Instrucciones Original

English
► Press the kickback stop function OFF button
four times at intervals of at least 0.5 sec­
onds within five seconds.
The kickback stop function status LED flashes
alternately red and green.
► Within 15 seconds
▷ Press the saw unit down.
▷ Lift the machine at the rear and lower it
again.
A signal sounds, the status LED lights up green.
The kickback stop function operates fault-free.
If no signal sounds and the status LED does not
switch to green, the kickback stop function is
not operating fault-free.
► Check whether the function testing was car­
ried out correctly.
► Clean the feeler unit behind the saw blade
(see "Changing the saw blade").
If the function testing remains unsuccessful,
the machine must no longer be used. Contact
your Festool service workshop.
9.8

Sawing along the scribe mark

The gauge marker [9-2] displays the cutting
line for 0° and 45° cuts (without a guide rail).
9
9-1
9-2
9.9 Cutting sections
Position the machine with the front part of the
saw table on the workpiece, switch on the ma­
chine, push it down to the set cutting depth and
push it forward in the cutting direction.
9.10 Sawing cut-outs (plunge cuts)
In order to avoid kickbacks, the following
instructions must always be followed
when plunge cutting:
– Always position the machine with the rear
edge of the saw table against a fixed stop.
– When working with the guide rail, position
the machine at the FS-RSP kickback stop
20
(accessory) [11-4], which is clamped to the
guide rail.
Procedure
► Place the machine on the workpiece and
position it at a stop (kickback stop).
► Switch on the machine.
► Slowly push the machine down to the set
cutting depth and push it forward in the cut­
ting direction.
The marks [9-1] indicate the absolute front and
rear cutting points of the saw blade (Ø 6‑1/4"
(160 mm)) when using the saw at maximum
cutting depth with the guide rail.

9.11 Gypsum and cement-bound fibreboards

Due to the high volume of dust, it is recom­
mended to use the cover ABSA-TS55/60 (acces­
sories) which can be mounted at the side at the
protective cover and a Festool mobile dust ex­
tractor.

10 Service and maintenance

WARNING
Risk of injury, electric shock
► Always remove the battery pack from the
power tool before performing any mainte­
nance or service work.
► All maintenance and repair work which re­
quires the motor housing to be opened
should always be carried out by an author­
ised service workshop.
CAUTION
Certain cleaning agents and solvents are
harmful to plastic parts.
► Some of these include, but are not limited
to: Gasoline, Acetone, Methyl Ethyl Ketone
(MEK), Carbonyl Chloride, cleaning solu­
tions containing Chlorine, Ammonia, and
household cleaners containing Ammonia.
Customer service and repairs must
only be carried out by the manufac­
turer or service workshops. Find the
nearest address at:
www.festoolusa.com/service
Always use original Festool spare
EKAT
4
parts. Order no. at:
www.festoolusa.com/service
5
3
2
1