Vertical Stand Assembly; Swing Arm Stand Assembly - Welch Allyn REF 88000A Instrucciones De Uso

20 Connections and Assembly

Vertical Stand Assembly

The Video Colposcope stand is shipped unassembled. Minimal assembly is required.
1. Remove the stand and base parts from their cartons.
2. Place base upside down on the floor and insert casters into holes on the bottom of
the base. (Do not place two locking casters next to each other.)
3. Place the base on the floor with casters down. Lock the two locking casters.
4. Place pole into the base, aligning the pin on the flange with the pin hole in the base.
Place bolt, spacer, and washer, oriented as shown, into the pole. Tighten securely
with the enclosed Allen wrench. (The assembly may need to be tilted.)
Washer
Spacer
Hex Bolt
Allen Wrench
Before using the Video Colposcope, refer to "Setting Up Video Colposcope" section
of this manual.

Swing Arm Stand Assembly

The Video Colposcope stand is shipped unassembled. Minimal assembly is required.
Note
1. To assemble the stand, remove the stand and base parts from the cartons.
BASE WEIGHS 58 LBS. YOU MAY REQUIRE ASSISTANCE TO LIFT IT.
Welch Allyn Video Colposcope
Locking caster
Align pin with hole