Safety Instructions; Symbols - Festool CTM MIDI I Manual De Instrucciones

English
Contents
1 Safety instructions.................................... 14
2 Symbols..................................................... 14
3 Parts of the machine.................................15
4 Technical data........................................... 15
5 Intended use..............................................15
6 Commissioning..........................................16
7 Settings......................................................17
8 Working..................................................... 18
9 Service and maintenance..........................19
10 Environment.............................................. 20
1

Safety instructions

Warning! Read and observe all informa­
tion and safety instructions. Failure to observe
the information and safety instructions may
lead to electric shocks, fires and/or serious in­
juries.
Keep all safety information and instructions
for future reference.
- This appliance must not be used by persons
(including children) with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge. Children need
to be supervised to ensure they do not play
with the device.
- If the mains power cable is damaged, it
must be replaced by an authorised service
workshop to prevent it posing a risk.
Warning Operators must be appropriately
-
instructed in the use of this machine.
- The mains plug must always be disconnec­
ted from the socket before performing
cleaning or maintenance tasks, when re­
placing consumables or when converting
the machine.
Warning Only use the electrical outlet
-
module on the machine for the purposes
specified in the instructions.
- Warning If foam or fluid starts to escape,
switch off the machine immediately.
Caution Regularly clean the water level
-
limiting device and inspect it for signs of
damage.
- Sound pressure level as per EN
60335-2-69/uncertainty K
70 dB(A)/3 dB
- Hand-arm vibration value as per EN
60335-6-69/uncertainty K
< 2.5 m/s² / 1.5 m/s²
14
When extracting dust that exceeds the
limit value or large volumes of oak or
beechwood dust, only extract from one dust
source (power or compressed-air tool).
Warning Device may contain hazardous
-
dust. Only have the device maintained and
emptied, and only have the filter replaced
by an authorised specialist using suitable
protective equipment.
- Always operate with the filter system in­
stalled!
Risk of explosion and fire: Do not extract:
-
- Sparks or hot dust;
- combustible or explosive materials (e.g.
magnesium, aluminium, petrol, diluting
agents);
- aggressive materials (e.g. acid, alkaline
solutions, solvents);
- chemically reactive materials, which
lead to the generation of heat, acids/
bases, gases, etc. (e.g. reactive two-
component materials, aluminium and
water).
- Observe all national safety regulations as
well as the material manufacturer's speci­
fications!
- Always use suitable protective equipment!
- If intact following a visual inspection, work
in a dry environment according to instruc­
tions!
- Check the plug and the cable regularly in
order to prevent a hazard. In the event of
damage, these must be replaced by an au­
thorised service workshop only.
- Do not lift or transport the device using a
crane hook or lifting gear.
2

Symbols

Warning of general danger
Risk of electric shock
Read the operating instructions/notes.
Wear a dust mask.
Warning! The machine may contain
hazardous dust!