Beninca CP.PONY 115 Manual Del Usuario página 20

Memorising pedestrian function (RADI>Ped)
The pedestrian function can be associated to any transmitter button. The pedestrian function envisions partial opening for 7
seconds, proceed as follows:
Press the [PGM] button to access programming or if the control unit is already in the programming
1
menu, press [5] until the Radi menu is displayed.
Press the [PGM] button to enter the Radi function.
2 The display shows the first sub-menu PP.
Press [5] to display the Ped sub-menu.
Press the [PGM] button to enter the Ped function.
3
The display shows the flashing PUSH message.
Press the BY transmitter button that is to be associated to the Pedestrian function within 10
4 seconds (e.g. if key 1 has already been associated to the Step-by-Step function, key T2 can be as-
sociated to the Pedestrian function).
5 The display shows OK to confirm memorisation.
The control unit goes back to the RADI>PED menu. To go back to the RADI menu, press the [PGM]
6 and [5] buttons at the same time. To exit programming, press the [PGM] and [5] buttons again at
the same time again or, alternatively, remove the power supply or wait 60 seconds.
Deleting transmitters (RADI>CLR)
Proceed as follows to delete a transmitter already inserted in the memory:
Press the [PGM] button to access programming or if the control unit is already in the programming
1
menu, press [5] until the Radi menu is displayed.
Press the [PGM] button to enter the Radi function.
2 The display shows the first sub-menu PP.
Press [5] to display the CLR sub-menu
Press the [PGM] button to enter the CLR function.
3
The display shows PUSH.
4 Press any transmitter button BY that is to be deleted within 5 s.
5 The display shows OK to confirm cancellation.
The control unit goes back to the RADI>CLR menu. To go back to the RADI menu, press the [PGM]
6 and [5] buttons at the same time. To exit programming, press the [PGM] and [5] buttons again at
the same time again or, alternatively, remove the power supply or wait 60 seconds.
The radio receiver in this product is compatible with the new ARC (Advanced Rolling Code) transmitters which, thanks to 128-bit
encryption ensure superior copy-security.
Storing new ARC transmitters is quite similar to that of normal rolling code transmitters with HCS coding, but be aware that:
1) ARC transmitters and Rolling Code HCS can not be stored in a single receiver.
2) The first transmitter memorized determines the type of transmitters to be used later. If the first transmitter memorized is ARC,
you can not store Rolling code HCS transmitters, and vice versa.
3) Fixed code transmitters may only be used in conjunction with Rolling code HCS transmitters. They are, therefore, not usable
in combination with the ARC transmitters.
4) If you want to change the type of transmitters it is necessary to proceed with a receiver reset (as described in the manual).
20
ARC compatible control unit
IMPORTANT, PLEASE READ CAREFULLY:
Radi
PMOT
Ped
Push
ok
5
PGM+
Radi
PMOT
Clr
Push
PRG
OK
5
PGM+