Installing The Product On A Rack Etc; Preventing Equipment From Falling Over - Pioneer PDK-TS10 Manual De Instrucciones

Installing the Product on a Rack etc.

Caution
When installing on a rack etc.,
hold the Plasma Display. If you
hold the speakers, they may be
damaged or twisted.

Preventing Equipment from Falling Over

After installing the stand, be sure to take special care to ensure that the equipment will not fall over.
Stabilizing on table or floor
Stabilize the equipment as shown in the diagram using
screws that are available on the market.
Note
To stabilize the equipment on a
table or on the floor, use screws
that have a nominal diameter of 6
mm (1/4 inch) and that are at
least 20 mm (13/16 inch) long.
When holding the Plasma Display
erect:
Position of table/floor screws
When stabilizing the stand to a table or the floor, use M6
with a length above 20 mm (13/16 inch).
Unit: mm (inch)
Min. 20 mm
(13/16 inch)
* : 50 inch display model
** : 43 inch display model
Dimension without speakers
When laying down the Plasma
Display:
120 575 (22-5/8)*
(4-23/32) 500 (19-21/32)**
Side View
5
En