Installing The Product On A Tv Table Etc; Installation Precautions - Pioneer PDK-TS25 Manual De Instrucciones

Installing the Product on a TV table etc.

Be sure to observe the following precautions when moving
or installing this product with a Plasma Display into a TV
table or other enclosure.
Precautions when moving
When moving the product more than a few
meters, first remove the speaker, then remove
the Plasma Display from the stand and move the
Caution
speaker, Plasma Display, and stand separately.
When detaching the Plasma Display from the
stand, be sure to follow the procedure described
in "Detaching the Plasma Display from the
Stand" on page 20.
Precautions when installing in a TV
table or other enclosure
When installing in a TV table or other enclosure, hold
the Plasma Display by the handles located on the rear
of the Plasma Display. If you hold the speakers, they
Caution may be damaged or twisted.
When the plasma display you have purchased is
PDP-507XD/507XA(under speaker models).
Hold the Plasma Display by its handles and from the sides.
When the plasma display you have purchased is
PDP-507XD/507XA(except under speaker models)/
PDP-427XD/427XA.
Hold the Plasma Display by its handles and from the
bottom.
under speaker

Installation precautions

Make sure that you always secure a space at least as large
as that shown in the following diagram in front of and
behind the table top stand.
TV table
Min. 30 mm
(1-3/16 inch)
Back
Front
Table top stand
Plasma Display
If the stand protrudes from the TV table, it could
cause unforeseen accidents such as the equipment
breaking or falling over.
Caution
When rotating, take care not to allow the display
to bump into walls or surrounding objects.
Protrusion is dangerous.
Range of angle rotation
Min. 30 mm
(1-3/16 inch)
17
En