Horizontal Installation; Attaching The Display Fittings To The Plasma Display; Attaching The Wall Mounting Unit To The Wall - Pioneer PDK-WM03 Manual De Instrucciones

Horizontal Installation

1. Attaching the Display Fittings to the Plasma Display

There are two display fittings, one for the right side, the other for the left. Mount the fittings so that their eye bolts
are at the inner side.
Eye bolt
アイボルト
For the Left

2.Attaching the Wall Mounting Unit to the Wall

Screw the wall mounting unit to the wall using commercially available anchors or the 6 M8 screws.
NOTE: Make sure that the anchors or
screws are fastened into sections of the wall
at which there are beams. (Use anchors or
screws that are suited for use on the type
of wall on which the unit is being mounted.)
For details, see the following Table of Wall
Material vs. Anchors and Screws.
1 Line up the screw holes (ø9, indicated on the diagram) at
the tops and bottoms of the display fittings (one each for
left and right sides) with the screw holes (M8) in the rear
panel of the plasma display, and fasten the display fittings
using 2 of the included M8 screws for each fitting.
Reference: (PDP-614MX only)
When using the PDK-TS06 optional stand , the display
fittings can be attached with the plasma display
mounted on the stand.
Remove the four M6 screws fastening the display
to the stand before attaching the display fittings.
When lifting the plasma display, do not allow the
For the Right
stand to be lifted together with the display. If the
stand were to come off, it could cause injury or
damage.
494.5
400
■ Table of Wall Material vs. Anchors and Screws
Wall Material
Gypsum board
Plywood
Concrete
Block
ALC
Mortar
Brick
Wooden posts
* The extraction strength should be 500 kg or greater per position.
E-4
950
Center
850
Anchor
* Do not mount on plaster or plywood boards.
Be sure to fasten into a beam.
All anchors (850) or bolt plugs (300)
Tie-Lock anchors (No. 25)
Coach screws (ø8 x 50)
591