Key Switch; Shredder Chute; Shredder Knives; Chipper Chute - Echo Bear cat Manual Del Propietário

3.4 keY SWiTch

modelS: all modelS
The key switch is used to start or stop the engine. see Figures
3.5 thru 3.8 for keyswitch locations. Refer to the engine manual
for further operating instructions.
Figure 3.5
Honda On/Off switch
Figure 3.6
Honda Eectric
Key Switch
Figure 3.7
Briggs Electric
On/Off Switch
Figure 3.8
Briggs Commercial
On/Off Switch
3 INCH CHIPPER/SHREDDERS

3.5 Shredder chuTe

modelS: all modelS
materials to be shredded are fed through the shredder chute to
the shredder knives.

3.6 Shredder kniveS

modelS: all modelS
The shredder knives shred material that is fed into the shredder
chute.

3.7 chiPPer chuTe

modelS: all modelS
materials to be chipped are fed through the chipper chute to the

chipper blades.

3.8 chiPPer bladeS
modelS: all modelS
The chipper blades chip material that is fed into the chipper
chute.

3.9 jack STand

modelS: 70580 & 70580S
Always have the jack stand retracted from the ground when
moving the unit. When in use, be sure the jack stand is down
and locked in position with the snap pin.
FEATURES & CONTROLS
13