Deleting A Preset - Urrea 6205 Manual De Usuario Y Garantía

ADDING AN ANGLE PRESET
1. From target angle screen, press and hold
UNITS button for 3 seconds.
2. ADD PRESET confirmation screen is dis-
played. Highlight YES menu selection using UP/
DOWN buttons then press ENTER button. NO
menu selection returns to main menu without
adding a PSET.
3. MINIMUM ANGLE screen is displayed. MINI-
MUM ANGLE is target value at which green
progress lights, audible alert and vibrator turn
on. Initial MINIMUM ANGLE value is value from
target angle screen. MINIMUM ANGLE can be
set from 0 to 360° by pressing UP/DOWN but-
tons. Once desired target angle value has been
set, press ENTER button.
4. MAXMUM ANGLE screen is displayed next.
MAXIMUM ANGLE is angle value above which
red progress lights turn on. Initial MAXIMUM
ANGLE value will be MINIMUM ANGLE plus
4%. MAXIMUM ANGLE value can be set to any
value greater than MINIMUM ANGLE by press-
ing UP/DOWN buttons. Once desired value has
been set, press ENTER button.
5. BATCH COUNT screen is displayed next. De-
fault value is zero. Batch count range is 0 to
99. Press UP/DOWN buttons to increment/dec-
rement batch count. Mode Count increments
each time target angle is reached if a batch
count of zero is entered. Mode Count decre-
ments if a non-zero batch count is entered and
resets to batch count value when count reach-
es zero. Once desired value has been set, press
ENTER button.
6. PSET target screen is displayed labeled with
next available PSET number from 01 to 50.
26
7. To enter additional angle presets, repeatedly
press ENTER button until target angle screen is
displayed and repeat steps above.
NOTE: To select a stored PSET or manual target
torque or angle mode, repeatedly press ENTER
button until desired PSET or manual mode is
displayed.
EDITING A PRESET
Edit PSET function gives user ability to edit
stored PSETS on wrench.
1. From Preset screen to be edited, press and
hold UNITS button for 3 seconds.
2. CHANGE PRESET screen is displayed. 3. High-
light EDIT selection using UP/DOWN buttons
then press ENTER button.
4. MINIMUM TORQUE or ANGLE screen is dis-
played. Value can be changed by pressing UP/
DOWN buttons. Once desired target torque or
angle value has been set, press ENTER button.
5. MAXMUM TORQUE or ANGLE screen is dis-
played next . Value can be changed by pressing
UP/DOWN buttons. Once desired target torque
or angle value has been set, press ENTER but-
ton.
6. BATCH COUNT screen is displayed next. Val-
ue can be changed by pressing UP/DOWN but-
tons. Once desired batch count value has been
set, press ENTER button.
7. PSET target screen is displayed labeled with
same PSET number.
NOTE: Pressing ENTER button while EXIT menu
selection is highlighted will exit without edit-
ing PSET.

DELETING A PRESET

Delete PSET function allows user to remove
stored presets from wrench.
1. From Preset screen to be deleted, press and
hold UNITS button for 3 seconds.
2. CHANGE PRESET screen is displayed. 3. High-
light DELETE menu selection using UP/DOWN
buttons and press ENTER button.
4. Target screen is displayed and deleted PSET
is no longer available for selection.
NOTE: Pressing ENTER button while EXIT menu
selection is highlighted will exit without delet-
ing PSET.
NOTE: When a PSET is deleted, all other stored
PSET's will retain their original PSET numbers.
When a new PSET is entered, it will be assigned
first available PSET number in sequence.