Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3. Use UP/DOWN buttons to select LOCK or UN-
LOCK selection.
4. Press ENTER button to accept selection and
exit to Configure menu.
NOTE: If LOCK is se-
lected without a Preset
configured, following
screen is displayed:
NOTE:
When
Preset
Lock is enabled, Clear
Memory
function
is
disabled and displays
following Locked mes-
sage if attempted:
NOTE: When Preset Lock is enabled, Clear Cycle
count function is disabled and displays Locked
message if attempted.
PRESET UNLOCK
When Preset Lock is enabled, a password is
required to access Configure menu. Refer to
Computorq Calibration Manual for Configure
password.
1. From target torque or angle screen, press
and hold ENTER button for 3 seconds. 2. High-
light CONFIGURE menu selection using UP/
DOWN buttons.
3. Press ENTER button to display Password
screen.
4. Follow password entry procedure found in
Computorq Calibration manual.
JOB MODE
Job Mode function allows user to enable or
disable wrench preset Job mode. When in Job
mode, wrench executes presets in order config-
ured and automatically switches to next preset
when batch count reaches zero. When in Job
mode wrench is locked and Preset lock icon is
displayed.
NOTE: When Job mode is enabled, password
entry is required to re-enter Configure menu
E N G L I S H •
(Refer to Computorq Calibration Manual for
Configure password). 1. From Configure menu,
use UP/DOWN buttons to highlight JOB MODE
selection then press ENTER button.
2. Job Mode enable/disable screen is displayed.
3. Use UP/DOWN buttons to select ENABLE or
DISABLE.
4. Press ENTER button to accept selection and
exit to Configure menu.
NOTE: Text "JOB" is
displayed
between
PSET
number
and
batch count when en-
abled.
SETTING DATE AND TIME
Set Date/Time function allows user to set real-
time-clock date and time for time stamping
data records, recording last calibration date
and notifying user of an expired calibration
interval.
NOTE: When date and time is set for first time,
In-Service date is also set and is used for calcu-
lating initial calibration interval (see "Setting
Calibration Interval" in Advanced Configura-
tion section).
1. From Settings menu, use UP/DOWN buttons
to highlight SET DATE/TIME selection then
press ENTER button.
2. SET DATE screen is displayed with year high-
lighted.
3. Use UP/DOWN buttons to set year then press
ENTER button to highlight month.
4. Use UP/DOWN buttons to set month then
press ENTER button to highlight day.
5. Use UP/DOWN buttons to set day then press
ENTER button.
6. SET TIME screen is displayed with hour high-
lighted.
7. Use UP/DOWN buttons to set hour then press
ENTER button to highlight minutes.
8. Use UP/DOWN buttons to set minutes then
press ENTER button to highlight seconds.
9. Use UP/DOWN buttons to set seconds then
press ENTER button.
10. Clock is set and Configure menu is dis-
played.
NOTA: Year selection will scroll up from 2013.
Month selection will scroll from 1 to 12. Day
selection will scroll from 1 to 31.
U se r's m a n ua l
31
Publicidad
Tabla de contenido
