Know Your Product; Operation; Prior To Initial Operation - SPARKY HD PROFESSIONAL FSPE 110 Instrucciones De Uso Originales

▪ Do not overload the machine: operate with
moderate pressure. Overloading occurs
when you apply excessive pressure, result-
ing in decrease of motor speed, which may
cause inefficient operation and possible fault
of the motor.
▪ Prior to sawing wood check the material for
the presence of screws or nails and remove
them.
▪ Always keep the cord away from the working
area of the power tool.
▪ Never use the machine with a damaged ca-
ble. Do not touch the damaged cable and pull
the mains plug when the cable is damaged
while operating. Damaged cables increase
the risk of electric shock.
▪ Keep work area clean. Blends of materials
are particularly dangerous. Dust from light
alloys can burn or explode.
▪ Always wait until the machine has come to a
complete stop before placing it down.
▪ The tool must be used only for its prescribed
purpose. Any use other than those men-
tioned in this Manual will be considered a
case of misuse. The user and not the manu-
facturer shall be liable for any damage or
injury resulting from such cases of misuse.
▪ To use this tool properly, you must observe
the safety regulations, the assembly instruc-
tions and the operating instructions found in
this Manual. All persons who use and serv-
ice the machine have to be acquainted with
this Manual and must be informed about its
potential hazards. Children and frail peo-
ple must not use this tool. Children should
be supervised at all times if they are in the
area in which the tool is being used. It is also
imperative that you observe the accident
prevention regulations in force in your area.
The same applies for general rules of occu-
pational health and safety.
▪ The manufacturer shall not be liable for any
changes made to the tool nor for any dam-
age resulting from such changes.
▪ Power tools must not be used outdoors in
rainy weather, or in moist environment (after
rain) or in close vicinity with easily flammable
liquids and gases. The working place should
be well lit.
6
EN

Know your product

Before using the power tool, familiarize your-
self with all the operating features and safety
requirements.
Use the tool and accessories only for the ap-
plications intended. All other applications are
expressly ruled out.
1. Handle
2. Name plate
3. Screw for fixing bevel cutting angle
4. Lever for pendulum action adjustment
5. Quick-grip blade system
6. Base plate
7. Roller guide
8. ON/OFF switch
9. Electronic regulator
10. Dust extraction adapter
11. Transparent guard
12. Hexagon wrench
13. Lock-on button

Operation

This power tool is supplied from single-phase
alternating current mains only. It is double insu-
lated according to EN 60745-1 and IEC 60745
and can be connected to grounded or not
grounded sockets. This power tool is radio sup-
pressed in compliance with EMC Directive.
This power tool is designed for sawing wood,
plastics and metals. Due to the additional ac-
cessories and a range of blades, this power
tool is suitable for a large range of applications,
including circular sawing.

PRIOR TO INITIAL OPERATION

▪ Make sure the power supply voltage corre-
sponds to the value indicated on the name
plate with technical data of the tool.
▪ Always check the position of ON/OFF switch.
The power tool must be connected to the
power supply socket only when this switch
is in OFF position. If the plug is connected to
a receptacle while the power switch is in the
ON position, the power tool will start operat-
ing immediately, which could cause a seri-
ous accident.
▪ Make sure that the cord and the plug are in
order. If the replacement of the supply cord
is necessary, this has to be done by the
manufacturer or his agent in order to avoid
a safety hazard.
FSPE 110 ● FSPE 111