Environment; Eu Declaration Of Conformity - Festool HK 55 EBQ Manual De Instrucciones

HK 55
GB

The splinterguard must be broken in before
first use, see chap. 10.2.
Every time before use, check that the cross cut-
ting guide rail is retracted correctly and have it
repaired, if necessary. Never use if automatic re-
traction is not operating correctly.
Connect saw to the cross cutting guide rail

Slide saw onto the cross cutting guide rail in
sawing direction.
The saw engages in the sliding block [9-2] .
The quick fastener [9-1] locks in behind the saw ta-
ble.
The saw is securely connected to the cross cutting
guide rail.
Loosen saw from the cross cutting guide rail.

Push saw forward slightly in sawing direction.

Turn quick fastener [9-1] to the front.

Remove saw towards the rear against the saw-
ing direction.
Cutting with the compound mitre saw

Open knob at adjustable stop [10-1].

Adjust angle at the scale [10-3].

Close knob at adjustable stop [10-1].

Adjust depth and angle of the saw, see ch. 7.3
and 7.3.

The saw's play on the cross cutting guide rails
can be set with the two setting jaws [10-2].
The saw must slide easily across the rail.

Place the adjustable stop [10-1] and the fixed
stop against the work piece and position the
cross cutting guide rail.

Switch saw on.

Push saw in direction of cutting.
Pendulum guard opens. Sawing commences.
WARNING
Protruding rotating saw blade
Risk of injury

Do not position hands near cutting area and saw
blade.

Do not place hands below the work piece.

Do not hold the workpiece in hand or place it on
your leg.

After cutting, switch off saw.

Pull back saw into initial position.

Remove cross cutting guide rail from work
22
piece.
blade; do not place down. If the saw or the pendu-
lum guard fails to return to its initial position, stop
the sawing process, disconnect the mains plug,
check whether the tool is functioning properly and
remove any trapped wood splinters.
may be placed down when in this position.

11 Environment

Do not dispose of the device in house-
hold waste! Recycle devices, accesso-
ries and packaging. Observe applica-
ble national regulations.
EU only: In accordance with European Directive on
waste electrical and electronic equipment and imple-
mentation in national law, used electric power tools
must be collected separately and handed in for envi-
ronmentally friendly recycling.
Information on REACh: www.festool.com/reach

12 EU Declaration of Conformity

Portable circular saw
HK 55 EBQ
HK 55 EQ
Year of CE mark: 2015
We declare under sole responsibility that this product
complies with all the relevant requirements in the follow-
ing directives, standards and normative documents:
2006/42/EG, 2004/108/EG (until 19.04.2016), 2014/
30/EU (from 20.04.2016), 2011/65/EU, EN 60745-
1:2009+A11:2010, EN 60745-2-5:2010, EN 55014-
1:2006+A2:2011, EN 55014-2:1997+Corrigendum
1997+A1:2001+A2:2008,
A1:2009+A2:2009, EN 61000-3-3:2013.
Festool GmbH
Wertstr. 20, D-73240 Wendlingen, Germany
Wolfgang Zondler
Head of Research, Development and Technical
Documentation
2015-07-13
WARNING! Risk of
injury! Saw with
exposed
Parked position – pendu-
lum guard closed. The saw
with cross cutting guide rail
Series no.
10008474
200162
EN 61000-3-2:2006+
saw