19 Safety instructions
38
It is important to follow these safety instructions to prevent personal
injury and property damage. These instructions apply in addition to the
safety instructions at your workstation.
It is essential that you read the user information before starting the
device.
Wear personal protective equipment (gloves, safety shoes, goggles).
Only transport the device carefully and when it is empty. The interior
of the unit can also be damaged by impacts or if it is dropped.
For additional transport routes, transport the device on transport
trolleys and secure it against falling down. Wear safety shoes.
Do not loiter under the unit during transportation and operation.
The water bath may only be operated with non-flammable fluids.
Only operate the unit in rooms that are well-ventilated, dry and free
of frost.
Place the device on a flat surface and a mat made of non-flammable
material.
Do not start the device if it is damaged or leaking.
Compare the mains voltage and frequency with the specifications on
the type plate.
Only connect the unit to a fused mains connection via a FI circuit
breaker (Ia=30 mA).
The mains plug is a safe isolator from the power supply network and
must be freely accessible at all times.
Check the mains cable for damage before initial operation of the
device.
Do not start the device if it has a damaged power cable.
Escaping water vapor can reduce the operational safety of other
devices in the vicinity of the water bath through condensation. This
must be observed during installation and operation of the water
bath.
Parts of the bath cover can assume high surface temperatures at
elevated working temperatures in continuous operation.
If the bath cover is opened in this condition, there is an additional
danger from the escaping hot water vapor.
Caution when touching!
Never use the device without bath fluid!
Do not reach into the bath fluid.
Do not drain the tempering medium when it is hot.
Safety instructions