Connecting To Power; Battery Operation; Radio Operation - Roadstar HRA-1500N Manual De Instrucciones

CONNECTING TO POWER

Before switching on make sure that the voltage of your electricity
supply is the same as that indicated on the rating plate.
For your own safety read the following instructions carefully
before attempting to connect this unit to the mains.
AC 230 V OPERATION
To operate the connect the plug end (7) into a 230V AC 50 Hz
electric source and set on main power (1).

BATTERY OPERATION

 Open the Battery Compartment (8) at the bottom of the radio
and insert six UM-2 batteries following the polarity diagram
shown inside the battery compartment.
 Batteries should be removed form the compartment if the unit
is not to be used for some time.
 Flat batteries should be removed from the unit to avoid
leakage.

RADIO OPERATION

1. Turn the unit ON (1) then move clockwise the Volume (6).
2. Extend the wire antenna (2) for FM Band. To optimize MW re-
ception turn horizontally the radio until reaching the best re-
ception position.
3. Select the desired radio Band: MW (3) or FM (4).
4. Tune to the desired station with the Tuning knob (5).
5. Adjust the volume by turning the VOLUME control (6).
6. Press the button (1) to switch ON the scale illumination
SPECIFICATIONS
AC:
FM:
MW:
Features and design could be subject to variations without prior
notice.
English
230V 50Hz
87.5 - 108MHz
530 - 1600kHz
2