Power Sources - Roadstar HRA-600D+ Manual De Instrucciones

cord and remove all the batteries, then turn the power back on after a few seconds.

POWER SOURCES

AC POWER: You can power your portable stereo system by plugging the AC/DC
adaptor into the DC plug (11) at the back of the unit and into a wall AC power outlet.
Check that the rated voltage of your appliance matches your local voltage.
BATTERY POWER: To use the radio with batteries, disconnect the AC/DC adaptor
and insert 4 × "LR6" batteries into the compartment (13).
Be sure that the batteries are inserted correctly to avoid damage to the appliance.
Remove the batteries when the radio will not be used for a long period of time, as this
will cause leakage to the batteries and subsequently damage to your radio.
TO USE THE RADIO
1. Press the [Power] button (1) to power on;
2. (The first time you power on the radio, the radio will scan the DAB radio stations
automatically. It will display and play the first station after the scan is done);
3. Select the band (DAB or FM) by pressing the [Mode] button (2);
4. Adjust radio frequency to your desired station by pressing
(4/5);
5. Adjust the volume with the [Volume Knob] buttons (3) to the desired level;
6. To power off the radio, press the [Power] button (1).
Note: For a better reception reorient the antenna (10).
TUNE DAB STATION
 To select the desired radio station use the [Channel -/+] button (4/5).
Note: In case there is No DAB Service, press & hold the [Menu] button (7) and
select "Full Scan" to start scanning.
FM STATION SCAN

Use the [Tuning +/-] buttons (4/5) to fine tune the frequency in a step of 0.05
MHz.

Press and hold the [Tuning +/-] buttons (4/5) to scan the previous/next availa-
ble station.
PRESET
There are 10 presets available for DAB and 10 presets for FM.
1. Set the desired radio station frequency as explained previously;
2. Press and hold the [Preset] button (9) and it will display "Save to P1";
3. Choose the number of preset by pressing [Channel -/+] button (4/5);
4. Press the [Enter] button (8) until the display shows "Preset Stored".
RECALL A PRESET STATION
1. Press the [Preset] button (9);
2. Select the desired preset by pressing
3. Confirm with the [Enter] button (8).
English
[Channel -/+] button (4/5);
[Tuning -/+] buttons
2