Power Supply; Radio Operation - Roadstar TRA-1957N Manual De Instrucciones

POWER SUPPLY

Battery Operation

Open the Battery Compartment (8) at the back of the unit.

Insert first 6 x UM-2 batteries following the polarity diagram shown inside the
battery compartment.

Batteries should be removed from the compartment if the unit is not to be
used for some time.

Flat batteries should be removed from the unit to avoid leakage.
AC Power Operation

Connect the AC Power Cord to your AC household mains outlet and switch
on the mains supply. Make sure the voltage is compatible.

Before switching on make sure that the voltage of your electricity supply is the
same as that indicated on the rating plate.

For your own safety read the following instructions carefully before attempting
to connect this unit to the mains.

RADIO OPERATION

1. Turn the VOLUME/OFF knob (1) until you hear a click.
2. Adjust the volume by turning the VOLUME control.
3. Turn the Tone Control (Hight/Low) for adjust the Tone (7).
4. Extend the telescopic antenna for FM Band. To optimize MW reception turn
horizontally the radio until reaching the best reception position.
5. Select the desired radio Band (FM/MW) with the Band selector (6).
6. Tune to the desired station with the Tuning knob (2).
7. To switch off the radio turn the volume knob counterclock-wise until a click is
heard.
HEADPHONES
Headphones should have a 3.5 mm diameter stereo plug and an impedance of
8-32 ohms, and should be connected to the HEADPHONES Socket (4). When
headphones are connected, the speaker iss automatically disconnected.
SPECIFICATIONS
AC:
Batteries:
FM:
MW:
Note: Specifications and the design are subject to possible modifications
without notice due to improvement.
All manuals and user guides at all-guides.com
230V ~ 50Hz
6 x UM-2
87.5 - 108 MHz
530 - 1600 kHz
English 2