Steren CCTV-960 Manual De Instrucciones página 104

13. SYSTEM CONFIGURATION
-UPGRADE: This option allows you to upgrade the DVR software via a USB memory.
Make sure that the USB device is connected properly and has the corresponding updates.
Follow the instructions on screen to begin the upgrade.
Once it has completed, you must restart the device before the changes will take effect.
-HDD MANAGE: Click the >> button to see the window used to format and confi gure the
DVR unit hard disk drive (HDD).
Note: Before making recordings the hard disk must be formatted using the DVR. To format
the HDD, you must log on as an administrator.
To format the hard disk, click the format button. The formatting process status is displayed in
the progress bar. Depending on the size of the HDD, the formatting may take a few minutes.
Click Exit to stop the formatting process.
-USB Manage: displays information of the connected USB memory device. To format the
device click on the format button.
-COPY SETTINGS TO USB: stores the information of the CCTV-960 settings on the storage
device. Connect the storage device to the USB port on the system.
-LOAD SETTINGS FROM USB: applies the settings of the storage device information to
CCTV-960. Connect the device to store data from the system to the USB port.
-AUTO MAINTAIN.
-HDD CAPACITY: this fi eld shows the total/available hard drive storage capacity.
-HARDWARE VERSION: displays the version of the DVR hardware.
-SOFTWARE VERSION: fi eld shows the current DVR software version.
-SOFTWARE RELEASE DATE: shows the date of the version of software installed.
-MAC ADDRESS: shows the MAC address of the DVR.
49 49