Preset Memory; Preset Tuning; Channel Scan; Direct Access Tuning - Kenwood KDC-BT742U Manual De Instrucciones

⁄
• You cannot Channel search until the category
information is acquired.

Preset Memory

Putting the channel in the memory.
1
Select the channel to put in the memory
Push the [AUD] knob towards right or left.
2
Enter Preset Memory mode
Press the [SEARCH] button.
3
Select the number to put in the memory
Turn the [AUD] knob or push it towards up or
down.
4
Determine the number to put in the memory
Press the [AUD] knob for at least 1 second.
Cancelling the Preset Memory mode
Press the [SEARCH] button.
⁄
• Only the channel number is stored. Category information
is not stored.

Preset Tuning

Recalling the channels in the memory.
1
Enter Preset Tuning Select mode
Press the [SEARCH] button.
2
Select a desired station in the memory
Turn the [AUD] knob or push it towards up or
down.
3
Recall the station
Press the [AUD] knob.
Cancelling Preset Tuning
Press the [SEARCH] button.

Channel Scan

Every receivable Channel is checked for 10 seconds.
1
Start Channel Scan
Select "CH-SCAN".
For how to select Function Control items, refer to
<Function Control> (page 6).
2
Release it when the channel you want to listen
to is received
Press the [AUD] knob.
Function of remote control

Direct Access Tuning

Entering the channel and tuning.
1
Enter Direct Access Tuning mode
Press the [DIRECT] button on the remote
control.
2
Enter the channel
Press the number buttons.
3
Do Channel Search
Press the [4] or [¢] button.
Cancelling Direct Access Tuning
Press the [DIRECT] button on the remote
control.
⁄
• If you make no button operation for 10 seconds, the
Direct Access Tuning mode is automatically canceled.
• If you cannot receive any signal in the input Channel due
to bad conditions on radio wave or other such problems,
"ACQUIRING SIGNAL"/ "NO SIGNAL" appears.
33
|
English