Publicidad
Idiomas disponibles
Idiomas disponibles
(1)
Monitor.
(120) Main structure.
(5)
Monitor support.
(50) Side bar (left).
(51) Side bar (right).
(146) Side bar base cover (Left).
(147) Side bar base cover (Right).
(128) Bottle of lubricant.
(17) Bottle holder.
(3)
Self-locking nuts M-8.
(55) Allen screw M-5x15.
(52) Allen screw M-8x75.
(79) Self-tapping screw 3.5x15
(153) Bottle.
Combination box spanner.
Allen key 5mm.
(135) Allen key 6mm.
Follow the instructions step by step to
assemble:
1. At least two people are needed for
this step.
When fitting the side bars, one person
should hold the side bar while the
other one tightens the screws (52).
This
will
prevent
accidents.
First, take the right-hand side bar (51),
Fig.1.
Insert the tip of the control cable (35)
tying it to the guide cable (N) inserted
in the side bar Fig.1, pull the tip out
through the top of the side bar, as
shown in Fig.1, then insert the side
bar into the bottom right-hand support
on the structure (120) and use screws
(52) to secure it.
2. At least two people are needed for
this step.
When fitting the side bars, one person
should hold the side bar while the
other one fits the screws (52). This will
prevent any possible accidents.
any
possible
3. Now take the left side bar (50) and
insert it into the bottom left-hand
support on the structure (120) and use
screws (52) to secure it.
4 Position the left and right base
covers (146) and (147) in the direction
of the arrow facing the corresponding
side bar, as shown in Fig.2 and attach
them by using screws (55), as shown
in Fig.2.
5. ATTACHING THE MONITOR
TUBE.-
Insert the tip of the control cable (35)
tying it to the guide cable (R) inserted
in the monitor tube Fig.2, pull the tip
out through the top of the monitor
tube, as shown in Fig.2, and making
sure not to pinch any of the cables
when inserting these onto the handrail
tubes in the direction of the arrows.
Now tighten using self-locking nuts (3)
Fig.2.
6. ATTACHING THE MONITOR.-
Take
the
terminals (H), (34) and (35), coming
out of the handlebar (5) Fig.3, to the
terminals (141), (140) and (139), of
the monitor, next take the screws (52-
175) and secure the monitor, making
sure not to pinch the cables.
7. Next, lift the two bottle holder (17)
over the sides of the monitor Fig.4 in
the direction of the arrow.
MOVEMENT & STORAGE.-
The unit is equipped with wheels
(113), Fig.6 to make it easier to
move. Make sure that the mains
cable is unplugged from the wall
socket.
18
monitor
(1),
connect
Publicidad
