Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
To prevent accidents DO NOT move
the treadmill across uneven floors.
MAINTENANCE.-
Use the bottle of lubricant (128) to
lubricate the inside of the belt Fig.7 in
order to keep your unit in top condition
and to ensure that friction between the
belt and the board is kept to a
minimum (due to different running
styles, always apply more lubrication
to the area where you place your feet
during the exercise).
It is advisable to lubricate the base of
the belt between the board and the
band depending on how often it is used.
<3
<6
1 year
6-12
6
months
>12
3
months
Note: This preventive maintenance schedule
is only meant for home use.
It is suggested to maintain the unit every
month for commercial use.
If the belt starts to slip after lubrication,
then check the tension of the belt. To
tension the belt, take the 6mm Allen
key (135) and with the machine set to
4km/h turn screws (R & L) one turn in
a clockwise direction.
ADJUSTING THE BELT.-
If your unit is not seated evenly on the
four contact points, this may cause the
belt (X) to shift sideways. Rigorous
quality control adjusts and checks the
running belt. However, due to weight
differences and individual styles of
running, the belt may be prone to shift
Hours per week
3-7
>7
6
3
months
months
3
2
months
months
2
1
months
month
sideways. If the belt does shift to the
left or right, stop the machine.
BELT OFFSET TO THE RIGHT.-
This procedure is very important.
Follow these steps. In order to adjust
the belt, set the unit in motion at a
speed of 4km/h.
If the belt has moved to the right, turn
screw (R) on the right-hand side of the
machine a 1⁄4 turn clockwise. Note the
position of the belt, if after one minute
the belt is not completely centred then
repeat the operation. If you see that the
belt has moved too far over to the left
then turn the right screw back slightly in
an anticlockwise direction Fig.8.
As soon as you have adjusted the belt
you can begin exercising again.
BELT OFFSET TO THE LEFT.-
In the event that the belt has moved to
the left, turn screw (L) on the left-hand
side of the machine a 1⁄4 turn
clockwise.
Note the position of the belt, if after
one minute the belt is not completely
centred then repeat the operation. If
you see that the belt has moved too
far over to the right then turn the left
screw back slightly in an anticlockwise
direction Fig.8.
Important: Overtightening of the belt
can lead to a loss of speed on the
machine and even stretch the belt
itself. Bear In mind that one turn of the
right screw (R) in a clockwise direction
has the same effect on the position of
the belt as one turn of the left screw
(L) in an anticlockwise direction.
Consequently,
excessive belt movement you can use
either of the two screws in order to
avoid overtightening the belt.
19
in
the
event
of
Publicidad
Tabla de contenido
