Multi-Cutter With Tool Attachments Safety; Fuel Safety - Maruyama M27QC Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Multi-Cutter with Tool Attachments
Safety
1.
Make sure the Unit is assembled correctly and that
the tool attachment is correctly installed and
securely fastened as instructed in the Assembly
section.
2.
Inspect the Unit before each use. Replace
damaged parts. Check for fuel leaks. Make sure
all fasteners are in place and tightened securely.
Follow the maintenance instructions beginning on
page US-18.
3.
Make sure the tool attachment does not rotate at
engine idle speed. Refer to Idle Speed Adjustment,
page US-18.
4.
Inspect the tool attachment head and replace any
parts that are cracked, chipped or damaged before
using the Multi-Cutter.
5.
Install all required shields and guards prior to
operating the Multi-Cutter or its attachments.
Note: Remove blade cover from Hedge Trimmer
attachments prior to operation.
6.
Never use a tool attachment head or replacement
parts that are not approved by MARUYAMA.
7.
Maintain the Multi-Cutter power unit and tool
attachments according to the recommended
maintenance intervals and procedures in the
Maintenance section on page US-18.
8.
Shut off the engine and wait until the tool
attachment head has completely stopped moving
before checking, performing maintenance on or
working on the Multi-Cutter.
9.
If running problems or excessive vibration occur,
stop immediately and inspect the unit for the
cause. If the cause cannot be determined or is
beyond your ability to correct, return the Multi-
Cutter with tool attachment to your servicing
dealer for repair.

Fuel Safety

1.
Gasoline is highly flammable and must be handled
and stored carefully. Use a container approved for
fuel to store gasoline and/ or fuel/ oil mixture.
2.
Mix and pour fuel outdoors, where there are no
sparks or flames.
3.
Do not smoke near fuel or Multi-Cutter, or while
using the Multi-Cutter.
4.
Do not overfill the fuel tank. Stop filling 1/4-1/2
in. (6 mm-13 mm) from the top of the tank.
5.
Wipe up any spilled fuel before starting the
engine.
6.
Move the Multi-Cutter at least 10 ft. (3 m) away
from the fueling location before starting the engine.
10 ft. (3 m) minimum
7.
Do not remove the fuel tank cap while the engine
is running, or right after stopping the engine.
8.
Allow the engine to cool before refueling.
9.
Drain the tank and run the engine dry before
storing the unit.
10. Store fuel and Multi-Cutter away from open
flame, sparks and excessive heat. Make sure fuel
vapors cannot reach sparks or open flames from
water heaters, furnaces, electric motors, etc.
— US-8 —

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

M30qc

Tabla de contenido