Installing The Water Line - Samsung RF4267HA Manual Del Usuario

cHEckING THE WATER DISPENSER LINE
A water dispenser with a filter is one of the helpful
features on your new refrigerator. To help promote
better health, the water filter removes unwanted
particles from your water. However, it does not sterilize
or destroy microorganisms. You may need to purchase
a water purifying system to do that.
In order for the ice maker to operate properly, a water
pressure of 20~125 psi is required.
Under normal conditions, a 170 cc (5.75 oz.) cup can
be filled in about 10 seconds.
If the refrigerator is installed in an area with low water
pressure (below 20psi), you can install a booster pump
to compensate for the low pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator is
properly filled. To do this, press the water dispenser
lever until the water runs from the water outlet.
Water line installation kits are available at extra
cost from your dealer. We recommend using a
water line installation kit that contains copper tubing
and ¼" compression nut.
Connecting to the water supply line
1. First, shut off the main water
supply.
2. Locate the
nearest cold
Cold water line
water drinking
line and install
the pipe clamp
and shut off
valve.
3. Connect the water line installation kit to the shut
off valve.
Cold water line
Pipe clamp
Shut off valve
10_ setting up
Pipe clamp
Shut off valve
Water line installation kit

INSTALLING THE WATER LINE

Connecting the water supply line to the
refrigerator.
There are several items that you need to purchase
to complete this connection.
You may find these items sold as a kit at your local
hardware store.
use copper Tubing
• ¼" copper tubing
• ¼" compression nut (1pc)
• Ferrule (2pc)
Refrigerator
compression
Nut (1/4")
(Assembled)
Ferrule
(Not supplied)
copper tubing
(Not supplied)
Household water supply line
1. Connect the household water line to the
assembled compression fitting.
- If you are using copper tubing, slip the
compression nut ( B ) (not supplied) and ferrule
(not supplied) on the copper tubing (not supplied)
as shown.
- If you are using plastic tubing ( B ) , insert the
molded end (Bulb) of the plastic tubing ( B ) into
the compression fitting.
Do not use without the molded end (Bulb) of
the plastic tubing ( B ).
cAuTION
2. Tighten the compression nut ( B ) onto the
compression fitting.
Do not over-tighten the compression nut ( B ) .
use Plastic Tubing
• ¼" plastic tubing
→ Molded end(Bulb)
• ¼" compression nut (1pc)
Plastic Tubing
(Assembled)
compression Fitting
(Assembled)
Molded end(Bulb)
compression nut (B)
(1/4") (Not supplied)
Plastic tubing (B)
or
(Not supplied)