Storing The Machine; Maintaining The Mowing Head - Stihl FSE 60 Manual De Instrucciones

English

Storing the Machine

For periods of 3 months or longer
Thoroughly clean the machine,
N
especially the cooling air inlets.
Take out the spool with nylon lines
N
and engage the ends of the lines in
the spool's notches. Clean and
inspect the spool.
The resilience and service life of the
nylon line can be increased by storing it
in a container filled with water.
Store the machine in a dry, high or
N
locked location, out of the reach of
children and other unauthorized
persons.
40
Maintaining the Mowing
Head
Placing Power Tool on the Ground
Switch off the power tool.
N
Lay your trimmer on its back with
N
the loop handle facing down and the
output shaft facing up.
Adjusting Nylon Line
2
1
Hold the rotating mowing head
N
above the ground – tap it on the
ground once – about 3 cm fresh line
is advanced.
The blade (1) on the deflector (2)
N
trims surplus line to the correct
length – avoid tapping the mowing
head more than once at a time.
Line feed operates only if both lines still
have a minimum length of 2.5 cm.
If the line is shorter than 2.5 cm:
WARNING
To reduce the risk of injury, always shut
off the engine before adjusting the
mowing line by hand.
FSE 60, FSE 71, FSE 81