Storing The Machine; Sharpening Metal Cutting Blades - Stihl FS 300 Manual De Instrucciones

English

Storing the Machine

For periods of 3 months or longer
Drain and clean the fuel tank in a
N
well ventilated area.
Dispose of fuel properly in
N
accordance with local
environmental requirements.
Run the engine until the carburetor
N
is dry – this helps prevent the
carburetor diaphragms sticking
together.
Remove, clean and inspect the
N
cutting attachment. Coat metal
cutting attachments with corrosion
inhibitor.
Thoroughly clean the machine.
N
Clean the air filter.
N
Store the machine in a dry and
N
secure location – out of the reach of
children and other unauthorized
persons.
80
Sharpening Metal Cutting
Blades
Use a sharpening file (special
N
accessory) to sharpen cutting
attachments that are only slightly
worn. For heavy wear and nicks,
use a grinding machine or take them
to a servicing dealer. STIHL
recommends the STIHL servicing
dealer
Sharpen frequently, removing little
N
material – two or three strokes of the
file are usually sufficient for simple
resharpening
1
1
2
2
Sharpen cutter blades (1) evenly –
N
do not change the profile of the
parent wheel (2)
More sharpening instructions can be
found on the packaging of the cutting
attachment. So keep the packaging in a
safe place!
Balancing
After sharpening about 5 times,
N
check cutting attachments with the
STIHL balancer (special accessory)
to see if they are out of balance and
rebalance them or take them to a
servicing dealer – STIHL
recommends the STIHL servicing
dealer
FS 300, FS 350, FS 380