STOK QUATTRO SGP4033N Manual Del Operador página 24

Clean burner tubes using one of the following three ways:
1. Bend a stiff wire into a small hook. Run the hook
through each burner tube several times.
2. Use a narrow bottle brush with flexible handle and
run through burner tubes several times. DO NOT use
a wire brush.
3. Wear eye protection then use an air hose to force air
into the burner tube and out through the burner port.
Clean any clogged port with an opened paper clip.
 Once burner tubes are clear of debris, use a wire brush to
remove food and dirt from the outer surface of the tubes.
 Check burner for damage. Normal wear and corrosion
may cause some holes to enlarge. Replace burners if this
happens.
NOTE: Burner tubes must reengage valve openings.
 Verify that the gas valve orifice is correctly positioned
inside burner inlet.
 Attach the electrode to the burner and carefully replace
the burners.
 Slide burners into brackets inside the grill and secure
burners using hitch pins.
 Reattach electrode wires to the electronic ignitor.
ELECTRONIC
IGNITOR
Fig. 31
MAINTENANCE
Fig. 32
ELECTRODE
WIRE
Fig. 33
24 - English
GAS VALVE
BURNER
ORIFICE
BURNER
ELECTRODE