Warranty Terms - Schulz SRP 3040E Manual De Instrucciones

SCREW AIR COMPRESSOR

WARRANTY TERMS

Schulz S.A., within the limits of these terms, does grant this product's first buyer/end user a warranty against material
or manufacturing defect in the air end for a period of 2 (two) years from date of purchase invoice (or warranty
registration by SCHULZ Authorized - Technical/Distributor) if and only if the with the following conditions are met:
The 1.000 (one thousand) hour period for lubricant oil change is respected (air end).
A.
B. Only approved lubricoolant and original SCHULZ repair/maintenance parts are used.
C. The compressor is not operated without air filter or with such a damaged one that effective filtration is lost, or with
the air/oil separator element showing restriction on the panel in excess of recommended maintenance interval.(air
end).
D. The remaining components of the compressor are warranted against manufacturing defects for a period of 1
(one) year (Including the legal warranty period first 90 [ninety] days), from date of original purchase or warranty
registration by SCHULZ Authorized- Technical Distributor.
GENERAL WARRANTY CONDITIONS
A. This warranty shall only be considered valid if the start-up is performed and registered by your SCHULZ
Authorized - Technical/Distributor and the presentation, to SCHULZ S.A. of the Technical Service Report and the
Technical Delivery Log.
B. SCHULZ assumes no liability for lost production due to equipment malfunction.
C. No warranty service will be performed without the original purchase documentation.
D. Wearing parts, such as the ones below, which are naturally worn out by regular use and that are affected by the
installation and the way the product is used are excluded from this warranty: air filter, oil filter, valves, hoses,
bearings, oil seal, oil level sight, valves, belt, electric components, electronic sensors, electronic interface,
separator element and lubricant oil. Schulz S.A. will only assume responsibility for the servicing expenses of the
above mentioned parts after evaluation by Schulz S.A. factory personnel and the identification of manufacturing
defects.
E. This warranty will not apply to cleaning and installation services, roller bearings re-lubrication, adjustments
requested by customer, change of lubricant oil and filters, nor to any damage caused to the product's external parts
or damage in general due to incorrect use, neglect, modifications, external agents, use of improper attachments,
inappropriate sizing for the application, shipping or delivery damage, physical modification (not authorized by
SCHULZ S.A.), use not in accordance with this instruction manual, inadequate electrical conductors, wrong
voltage electrical connections or installation in a system subject to excessive voltage fluctuations.
F. Schulz S.A. warrants the electric motor and the electric switch to the extent that these items are warranted by their
manufacturers. Said manufacturers and SCHULZ S.A. reserve the right to subject failed components to the
manufacturers' evaluation. Defects resulting from installation errors are not covered by this warranty.
G. The warranty of the Electronic Interface and sensors shall only apply if they have not been violated. The warranty
will not cover parameter modifications of the Electronic Interface when performed by unauthorized persons.
Therefore, compressor failures, stops, damage or production losses resulting from such procedures are not the
responsibility of SCHULZ S.A. or the component manufacturer.
H. The input voltage to the compressor must be maintained within a variation of ± 10% (Electronic Interface).
WARRANTY TERMINATION
This warranty will be considered void in the following situations:
A. At the end of its warranty period.
B. When the product is delivered for servicing to unauthorized shops.
C. When signs of modification are noted.
D. When maintenance has not been performed to SCHULZ standards or repair parts used are not SCHULZ original
parts.
WARNINGS
A. This compressor is supplied according to the customer's technical specifications at the time of ordering. It has
specific displacement, pressure and voltage characteristics that cannot be changed, modified or altered in any
way.
B. Lubrication of your rotary screw air compressor is fundamental. Maintenance of proper lubricoolant levels is
paramount and has been discussed numerous times in this manual.
C. Expenses related to the servicing of the compressor which are judged to be outside the warranty parameters are
the customer's responsibility.
D. Dealers, representatives or SCHULZ Authorized - Technical/Distributor are not authorized to change these terms
or to assume responsibilities on behalf of SCHULZ S.A.
E. Drawings, dimensions and photos are intended to show component flow and orientation only and are not
intended to be a specification drawing. Specification drawings are available upon request from SCHULZ S.A. only.
F. The SCHULZ technician will provide service on a first come first served basis.
G. This SCHULZ product is supplied with tracking control of its components.
Note: Schulz S.A. reserves the right to make changes to these warranty policies without prior notice.
62
SRP 3040E - SRP 3040