TFA Dostmann MAXIM II Manual De Instrucciones página 28

before reinserting them. Once the indoor data is displayed user may
proceed to the next step.
3. After the batteries are inserted, the thermo-hygro-station will start
receiving data signal from the transmitter. The outdoor temperature
and humidity data should then be displayed on the thermo-hygro-
station. If this does not happen after 2 minutes, the batteries will
need to be removed from both units and reset from step 1.
4. In order to ensure sufficient 868 MHz transmission however, the
distance between the thermo-hygro-station and the transmitter
should not be more than 100 meters (see notes on "Positioning"
and "868 MHz reception").
Note: In the event of changing batteries of the units, ensure the batteries
do not spring free from the contacts. Always wait at least 1 minute after
removing the batteries before reinserting, otherwise start up and
transmission problems may occur.
WHEN MORE THAN ONE TRANSMITTER IS USED
1. User shall remove all the batteries from the thermo-hygro-station
and transmitters, and wait 60 seconds.
2. Insert the batteries in the first transmitter.
3. Within 2 minutes of powering up the first transmitter, insert the
batteries in the thermo-hygro-station. Once the batteries are in
place, all segments of the LCD will light up briefly. Following the
indoor temperature/humidity and the time as 0:00 will be displayed.
If this information is not displayed on the LCD after 60 seconds,
remove the batteries from both units and wait for at least 60
seconds before reinserting them.
4. The outdoor temperature and humidity data from the first transmitter
(channel 1) should then be displayed on the thermo-hygro-station.
Also, the signal reception icon will be displayed. If this does not
happen after 2 minutes, the batteries will need to be removed from
both units and reset from step 1.
5. Insert the batteries in the second transmitter as soon as the outdoor
temperature and humidity readings from the first transmitter are
displayed on the thermo-hygro-station.
Note : User shall insert the batteries into the second transmitter
within 45 seconds after the thermo-hygro-station displays the
information of the first transmitter.
6. The outdoor temperature and humidity from the second transmitter
and the "channel 2" icon should then be displayed on the thermo-
27