TFA Dostmann MAXIM II Manual De Instrucciones página 39

POSITIONING THE THERMO-HYGRO-STATION
The thermo-hygro-station provides the option of table standing or wall
mounting the unit. Before wall mounting, please check that the outdoor
data can be received from the desired locations.
POSITIONING THE THERMO-HYGRO TRANSMITTER
To wall mount:
1. Fix a screw (not supplied) into the desired
wall, leaving the head extended out by about
5mm.
2. Place the thermo-hygro-station onto the
screw, using the hanging hole on the
backside. Gently pull the thermo-hygro-station
down to lock the screw into place.
Foldout table stand:
The foldout table stand leg is located on the
backside. Pull the stand out from the bottom
center edge of the thermo-hygro-station, below
the battery compartment. Once the foldout table
stand is extended, place the thermo-hygro-
station in an appropriate location
Table stand/wall
mount bracket
38
The thermo-hygro transmitter
can be placed onto any flat
surface or wall mounted using
the bracket which doubles as a
stand or wall mount base.
To wall mount:
1. Secure the bracket onto
a desired wall using the
screws and plastic
anchors.
2. Clip the transmitter onto
the bracket.