Technical Data; Hints For Test Institutes - AEG FAVORIT 44010 VIL Manual De Instrucciones

The dishes are wet and dull
There are streaks, milky spots or a bluish coating
on glasses and dishes
Water drops have dries onto glasses and dishes • Increase rinse aid dosing.
If after all these checks, the problem persists, contact your local Service Force Centre.

Technical data

Dimension
Electrical connection - Voltage
- Overall power - Fuse
Water supply pressure
Capacity
Max. weight

Hints for test institutes

Testing in accordance with EN 60704 must be carried out with appliance fully loaded and
using the test programme (see "Washing programmes").
Test in accordance with EN 50242 must be carried out when the salt container and rinse
aid dispenser have been filled with salt and rinse aid respectively and using the test pro-
gramme (see "Washing programmes").
Amount of detergent required:
Rinse aid setting:
Example loading arrangements:
Upper basket
The wash results are not satisfactory
Width - height - depth (cm)
Information on the electrical connection is given on the rating
plate on the inner edge of the dishwasher's door
Minimum - Maximum (MPa)
Place settings
kg
Full load: 12 standard place settings
1)
• Rinse aid was not used.
• The rinse aid dispenser is empty.
• Decrease rinse aid dosing.
• The detergent may be the cause. Contact the
detergent manufacturer's consumer care line.
59,6 x 86,8-94,8 x 55,5
0,05 - 0,8
12
45
5 g + 25 g (Type B)
position 4 (Type III)
23
Technical data