Gaggia Milano CLASSIC Instrucciones De Uso página 22

NOTE: Use the GAGGIA descaling
product only. Its formula has been
designed to ensure better machine
performance and operation for its
whole operating life. If correctly
used, it also avoids alterations in the
brewed product. The descaling solu-
tion is to be disposed of according
to the manufacturer's instructions
and/or regulations in force in the
country of use.
NOTE: Never drink the descaling solution or any products
dispensed until the cycle has finished. Never use vinegar
as a descaling solution.
1 Insert the filter holder into the brew unit from the bottom
and turn it from left to right until it locks into place.
2 Remove and empty the water tank.
3 (Fig.02) - Pour HALF the content of the GAGGIA
concentrated descaling solution into the water tank, and
then fill the tank with fresh drinking water up to the MAX
level.
4 Remove the Pannarello (or Cappuccinatore) installed on
the steam wand, if any.
5 Switch on the machine by pressing the ON/OFF button
(1).
(Fig.03) - Fill up (as described in the Section "Making
hot water" of the manual) two cups of water (about 150
ml each) from the steam/hot water wand and turn off
the machine by pressing the ON/OFF button (1).
6 Leave the descaling solution to descale for approx.15-20
minutes with the machine turned off.
7 Switch on the machine by pressing the ON/OFF button
(1).
(Fig.03) - Fill up (as described in the Section "Making
hot water" of the manual) two cups of water (about
150ml each) from the steam/hot water wand. Then turn
the machine off by means of the ON/OFF button (1) and
leave it off for 3 minutes.
8 Repeat the operations as described in step 7 until the
water tank is completely empty.
9 (Fig.02) - Rinse the tank and fi ll it again with fresh
drinking water.
10 (Fig.03) - Place a container under the steam wand
(Pannarello). Open the knob (7) slowly by turning it
counter-clockwise. Press the hot water/brew button (2)
and steam button (4).
11 Dispense the whole water tank from the steam/hot
water wand. To stop dispensing, press the hot water/
brew button (2) and the steam button (4) again. Then
close the knob (8) by turning it clockwise.
12 (Fig.02) - Fill the water tank with fresh drinking water.
13 Place a suitable container under the filter holder.
14 Press the brew button (2) and dispense all the water in
the water tank. Once the tank is empty, stop dispensing
by pressing the brew button again (2). At the end, empty
the container.
15 Remove the filter holder from the unit by turning it from
right to left and rinse it with fresh drinking water.
16 Repeat the operations once again from point (9) for a
total of 4 tanks. The machine is now ready to be used.
The descaling cycle is now complete.
(Fig.03) - Fill the tank again with fresh water.
If necessary, prime the circuit as described in Section "Starting
up" of the manual.
Once finished, reposition the Pannarello (or Cappuccinatore)
on the steam wand.
• 17 •
ENGLISH