Connecting
a VCR
Video Connection
These instructions assume that you have already connected your TV to an antenna or a cable TV system (according to the
instructions on pages 11-12), Skip step I if you have not yet connected to an antenna or a cable system,
1
2
Unplug the cable or antenna from
the rear of the TV
Connect the cable or antenna to
the ANT IN terminal on the rear of
the VCR.
\\\\\\
.. _.
\\
Connect an Antenna Cable
between the ANT OUT terminal
on the VCR and the ANT I IN
(CABLE) orANT 2 IN (AIR)
terminal on the TV.
Connect a Video Cable between
theAV IN 1 [VIDEO] (orAV IN 2
[VIDEO]) jack on the TV and the
VIDEO OUT jack on the VCR.
Connect Audio Cables between the
AV IN 1 [L-AUDIO-R] (orAV IN 2
[L-AUDIO-R]) jacks on the TV and
the AUDIO OUT jacks on the VCR.
_-
If you have a "mono"
(non-stereo) VCR, use a
Y-connector (not supplied) to
hook up to the right and left
audio input jacks of the TV. If
your VCR is stereo, you must
connect two cables.
VCR
TV Rear Panel
Each VCR has a different panel configuration.
_-
When connecting a VCR, match the color of the connection terminal to the cable.
S=Video Connection
Your 8amsung TV can be connected
to the 8=Video jack of a VCR,
(This connection delivers a better
picture when compared to the
regular video connection above.)
1
To begin, follow steps 1-3 in the
previous section to connect the
antenna or cable to your VCR and
your TV.
2
Connect an S-Video Cable
between the AV IN I [S-VIDEO]
(orAV IN 2 [S-VIDEO])jack on the
TV and the S-VIDEO OUT jack on
the VCR.
3
ConnectAudio Cables between the
AV IN 1 [L-AUDIO-R] (orAV IN 2
[L-AUDIO-R]) jacks on the TV and
the AUDIO OUT jacks on the VCR.
VCR
J-
::::::::::::::::::::::::::::
TV RearPanel
Each VCR has a different panel configuration.
_-
When connecting a VCR, match the color of the connection terminal to the cable.
_-
Some games may be displayed with a cut off picture when the TV is connected to a game player.