Replacing The Lamp - Samsung HL-T5656W Instrucciones Del Propietario

Replacing the Lamp
_' do I need to replace the lamp?
® The lamp used in a DLP TV has a limited lifespan. For the best screen quality it needs to be replaced periodically.
After replacing the lamp, the screen quality will be bright and clear as new.
When do I need to replace it?
® It should be replaced when the screen becomes darker, less clear or when all three LEDs on the front (TIMER, LAMP, & STAND
BY/TEMP) are flashing.
Check before lam_lacement
® The lamp must be the same code number and type.
® The lamp type is indicated on the rear of the TV. It is also indicated on the lamp case.
® After checking the code number for the lamp, give the code number to the store where you purchased the TV or to a Samsung
Service center.
Caution
® Replace with the correct code numbered lamp to avoid damage to the TV.
® Turn the power off and wait for 30 minutes before replacing the lamp as it will be hot.
® Do not touch the glass part of the lamp with your bare hands and do not insert any foreign object inside the cover as it may cause
poor screen quality, electric shock or fire.
® Do not place the old lamp near flammable objects or within the reach of children.
® Be sure to connect this TV directly to an AC wall outlet. If the TV's AC plug is connected to a cable box or other source, it will not
allow for proper cool down time.
_-- For replacement, you will need a 5.91-Inch screwdriver and a pair of gloves.
1 Unplug the TV, then use a screwdriver to remove the screws.
2 Removethe Lamp cover.
3 Remove the Lamp cover duct holding the word clip and pulling
it out.
4 Remove the screw securing the Lamp by using a screwdriver.
5 Separate the Lamp from the engine by holding the handle and
pulling it out.
_- • Be sure the replacement Lamp is the same type.
• After replacing the lamp, align the lamp cover with the groove and secure the screws.
• The TV will not turn on if the lamp cover is not correctly closed (as this will activate the protective circuit).