Operation; Installing The Mattress Overlay System (Ma50Ce) - Invacare MicroAIR MA50CE Serie Manual Del Usuario

4 Operation

CAUTION
The control unit and overlay on the MA50CE series are designed to be used as a system. DO NOT replace overlays or control units
with other models or other brands. Otherwise, damage to the system may occur. Contact your supplier to get the correct replacement
if needed.
4.1

Installing the Mattress Overlay System (MA50CE)


The overlay system comes with the following straps - head end elastic strap, foot end elastic strap and two buckle straps.
1. If necessary, lower the side rails to facilitate installation of the
overlay.
2. Place the overlay directly over the existing foam mattress.
3. Loop the head end elastic strap around the head end of the existing
foam mattress.
4. Loop the foot end elastic strap around the foot end of the existing
foam mattress.
5. Secure the overlay to the existing foam mattress using the two
buckle straps.
 Ensure that the side rails
can move freely.
Corner Rings and cable
management system help
manage sheets and power
cord to keep neat and safe.
Part No 1176084
Corner
Ring
15
FIGURE 1 Installing the Mattress Overlay System (MA50CE)
4 OPERATION
Mattress Overlay
Foam Mattress
Foot End
Elastic Straps
Buckle Strap
Invacare® MA50CE Series