Torque Limiter Adjustment Using Spring Scale - RIDGID K-1000 Manual Del Usuario

K-1000 Rodder
1" Socket
Screw (2)
Screw (Long)
Figure 4 – Adjusting Torque Limiter
Torque Testing
Tool
Cap Screw (3)
Figure 5 – Torque Limiter, Torque Testing Tool, Drive Sprocket and Drive Shaft
10. Remove hex key or pin that was installed to secure
chain.
11. Remove torque wrench, drive pin and torque test-
ing tool.
12. Install guard and secure with 3 screws. One screw is
longer than others and is used in lower right hand
side.
13. Connect spark plug.
10
Torque Wrench
(50 Ft. Lb. (68 Nm)
Reading Required)
Cap Screw (3)
Drive Pin
Drive Shaft A-3548
Drive Sprocket
Fiber Disc
Backup Plate
Threaded Ring
Threaded Ring
Backup Plate
Torque Testing Tool
Guard
Backup Plate
Fiber Disc
Torque Limiter
Torque Limiter Adjustment Using Spring
Scale
1. Follow steps 1 through 7 of Torque Limiter Adjust-
ment using Torque Wrench.
2. Snap socket drive handle into a 1 inch socket and
install on torque testing tool.
3. Measure 12 inches (30 cm) from center of socket
along socket drive handle and attach spring scale.
4. Pull on spring scale until torque limiter slips. Scale
should read 50 lbs (22 kg).
Fiber Disc
Drive Sprocket A-3569
Hex Key or Pin
Drive Sprocket
Chain A-3568
Drive Pin
Drive Shaft
Threaded Ring
Retainer
Pressure Plate