Using With The Base; Overhang; Adjusting The Recline Angle - Britax B-SAFE 35 Guia Del Usuario

BRITAX Child Safety, Inc.

Using With the Base

Before installing the infant car seat:
• Check that your vehicle seat belt is compatible with
the infant car seat by referring to your vehicle owner's
manual and page 38 in this user guide.

Overhang

It is important that the base of
the child seat rests completely
flat on the vehicle seat� As
seen in the illustration, it is
permissible to allow up to
3 in� (7�6 cm) of the base to
hang over the edge of the
vehicle seat� Some vehicle
seats do not allow enough of
the child seat base to contact
the vehicle seat� If this is the
case, choose another seating
position� Not doing so could
cause the child seat to not
perform as intended�

Adjusting the Recline Angle

IMPORTANT: Vehicle must be
parked on a level surface.
1. Pull up on the recline
adjustment lever.
10
3"
2. Move the base up or down
until the red marker is
visible between the two
lines on the recline angle
indicators while on the
vehicle seat.
If there is difficulty achieving the proper recline angle after
installing, try another approved seating position in your
vehicle or:
a. Uninstall the base and lower the recline angle
adjustment foot to the lowest position.
b� Remove the base from
the vehicle and place
a rolled towel or pool
noodle in the vehicle
seat bight�
c� Place the base against the towel or pool noodle to
level the shell and install.
NOTE: If a towel or pool noodle is needed for the
recline angle, the recline angle adjustment foot on the
base should remain in its lowest position.
B-SAFE 35 User Guide
ü
û
11