Safety Instructions; General Instructions; Intended Use Of The Machine; Personal Protective Equipment - Dolmar ME-246.4 Instrucciones De Manejo

SAFETY INSTRUCTIONS

General instructions

- To ensure correct operation, user has to read this instruction manual to
make himself familiar with the handling of the equipment. Users insufficiently
informed will risk danger to themselves as well as others due to improper
handling.
- It is recommended only to lend the equipment to people who have proven to
be experienced with equipment.
Always hand over the instruction manual.
- First users should ask the dealer for basic instructions to familiarize oneself
with the handling of an engine powered cutter.
- Children and young persons aged under 18 years must not be allowed to
operate the equipment. Persons over the age of 16 years may however use
the device for the purpose of being trained only whilst under supervision of a
qualified trainer.
- Use the equipment with the utmost care and attention.
- Operate the equipment only if you are in good physical condition. Perform all
work calmly and carefully. The user has to accept liability for others.
- Never use the equipment after consumption of alcohol or drugs, or if feeling
tired or ill.
- Never attempt to modify the equipment.
- National regulations may restrict of the use of the equipment. Follow the
regulations about handling of pole saws and chain saws in your country.

Intended use of the machine

This equipment is designed only for the purpose of pruning branches and limbs
less than 15 cm in diameter. Never use the equipment for the other purpose.
Abusing the equipment may cause serious injury.

Personal protective equipment

- The clothing worn should be functional and appropriate, i.e. it should be tight-
fitting but not cause hindrance. Do not wear either jewelry or clothing which
could become entangled with bushes or shrubs.
- In order to avoid either head-, eye-, hand-or foot injuries as well as to protect
your hearing the following protective equipment and protective clothing must
be used during operation.
- Always wear a helmet where there is a risk of falling objects. The protective
helmet (1) is to be checked at regular intervals for damage and is to be
replaced at the latest after 5 years. Use only approved protective helmets.
- The visor (2) of the helmet (or alternatively goggles) protects the face from
flying debris and stones. During operation always wear goggles, or a visor to
prevent eye injuries.
- Wear adequate noise protection equipment to avoid hearing impairment (ear
muffs (3), ear plugs etc.).
- The work overalls (4) protect against flying stones and debris.
We strongly recommend that the user wears work overalls.
- Special gloves (5) made of thick leather are part of the prescribed equipment
and must always be worn during operation.
- When using the equipment, always wear sturdy shoes (6) with a non-slip
sole. This protects against injuries and ensures a good footing.
- When handling the saw chain or adjusting the chain tension, wear protective
gloves. Saw chain can cut bare hands severely.
3