Tabla de contenido
Publicidad
Funcionamiento manual del flash
M
m
1
Fig. 10 / Grabado 10
Manual flash mode
Modo flash manuale
mm
Auto Zoom
4.2 Manual flash mode
Various cameras automatically switch the
mecablitz to TTL flash mode when in Pro-
gram "P" (or "HYP" or "green square") or in
one of the Subject Program Modes. Manual
flash operation is then no longer possible.
There is no correct exposure confirmation
given on the mecablitz LC display in the
manual flash mode!
Set „"A" or Av" aperture priority or the „M" (or
„HYM") manual modes on the camera. Select the
aperture and shutter speed (with „M") on the
camera according to the given photographic
situation (see the camera's operating instructions).
4.2.1 Manual flash mode M with full light
output (Fig. 10)
In this mode the mecablitz always fires uncon-
trolled flashes at full light output. Adaptation to
the given photographic situation is only by adju-
sting the aperture setting on the camera accor-
dingly. The mecablitz LC display will indicate the
flash-to-subject distance that has to be maintained
for a correct exposure (see also 7.4.2).
Setting procedure for the manual flash mode M
• Turn on the mecablitz by its main switch.
Continue depressing the „Mode" key until „M"
1
flashes on the LC display.
• The setting becomes immediately effective. The
LC display is returned to its normal state after
approx. 5 sec.
4.2.2 Manual flash mode MLo with partial
light output (Fig. 11)
In this mode the flash unit always fires uncon-
trolled flashes at 1/8th (Low) of full light output.
Adaptation to the photographic situation is by se-
lecting a corresponding aperture setting on the
camera. The mecablitz LC display will indicate the
flash-to-subject distance that must be maintained
for correct exposure (see also 7.4.2).
26
Publicidad
Tabla de contenido
